Jump to content
SAU Community

Recommended Posts

Hey guys,

have a 1995 R33 GTR that has developed a bad miss at low revs or cruising speed. under load it runs perfect, but try to cruise and it misses or taking off until it gets up to 3k rpm or higher in first then its fine. Occassionally it will start and die straight away or run perfect for a day or so before playing up again.

Have cleaned both and resoldered the primary AFM and replaced fuel pump.

Have search everywhere i can but no certain answers.

Any ideas what else to check or replace as its dangerous it cutting out power when we try to take off.

cheers

Link to comment
https://www.sau.com.au/forums/topic/440001-r33-gtr-miss/
Share on other sites

we didnt run a new power from the battery.

Most likely this is your problem, at least it's an easy fault to remedy. There is a 'how to' in the tutorial section for running the direct power feed.

http://www.skylinesaustralia.com/forums/topic/91993-fuel-pump-direct-feed-rewire/page-15

Link to comment
https://www.sau.com.au/forums/topic/440001-r33-gtr-miss/#findComment-7215813
Share on other sites

Walbro's don't like the low power the factory pump controller puts out at idle and cruise. Was it a 255 you installed?

I gave you a simple answer to your dilemma, now go wire a relay in and let us know how it runs afterwards. :)

Link to comment
https://www.sau.com.au/forums/topic/440001-r33-gtr-miss/#findComment-7215897
Share on other sites

Perhaps the stock pump had failed, no surprise there... I know for a fact the Walbro's can cause poor running like this if running low voltage. Most aftermarket pumps can have similar issues.

I have had many customers buying them off me and telling me they are shit and wanting their money back, even after I explain they need full 14v. It's probably half the reason they got such a bad name. The twin 255's are running fine in my car 5 years later, with constant e85 use.

Link to comment
https://www.sau.com.au/forums/topic/440001-r33-gtr-miss/#findComment-7216200
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
    • Does the scanner do all the CUs in the car, or only the ECU?
    • @666DAN sorry to bring you and old thread.     I've got my de+t done and it's all running great other than 1 small issue.    Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd when selected . But nothing when in  drive or what gear your in when you pop it into tiptronic. I'm sure there is maybe 1 wire in the ecu plug I need to move to rectify this. Do ya have any ideas?     Cheers man
    • Well I recently changed my rear axles and was thinking if I bumped anything, I have been driving the car for a while now though... But it has been raining today so everything is wet under the wheel arches. Brakes feel fine and can't hear any of the metal screamers, I had a squeak coming from one of the handbrake drums but that seems to have gone away a while ago. I was going down a hill when it lit up and I did feel the abs bite for a second and question why it did it?
×
×
  • Create New...