Jump to content
SAU Community

Recommended Posts

Hi guys,

I've just had my old s14 project car rolling shell interior, engine bay and boot painted and it's for sale. The roll cage cost $3k and is CAMS approved. Perfect for anyone wanting a shell ready to drop in your choice of motor and gear box. Rolling chassis, comes with an sr20det, unknown condition of motor, was running when removed. Comes with S14.5 Origin +25mm conversion fenders, body loom, pedals. Boot lid and tail lights available if buyer wants them, but no use on the shell as the hinges and rear parcel shelf have been cut out. Has got tubs welded in too. No turbo, No headlights No rear bar, No gearbox. Not registered.

Asking price for shell is $6000.

Have a few additional parts if buyer wants them with the shell, at EXTRA cost as per below.

5 piece lexan window kit +1000

Fibre glass doors (brand new) +950

Fibre glass "Edge" side skirts (brand new) +250

S14 Origin +50mm rear fenders (brand new) +450

S15 C-west Front bar +400

C-west carbon fibre GT Wing II +1000

Also if you are not genuinely interested in buying it, no one wants to read your commentary from the sidelines.

post-10650-0-11519100-1394421094_thumb.jpg

post-10650-0-33814900-1394421100_thumb.jpg

post-10650-0-04583000-1394421105_thumb.jpg

post-10650-0-16502800-1394421110_thumb.jpg

post-10650-0-74655600-1394421116_thumb.jpg

post-10650-0-49693400-1394421124_thumb.jpg

post-10650-0-18920100-1394421132_thumb.jpg

post-10650-0-07098500-1394421581_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/440296-s14a-200sx-rolling-shell/
Share on other sites

  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...