Jump to content
SAU Community

R33 Series 1

torquetalker
 Share

Recommended Posts

torquetalker Enthusiast

torquetalker

Posted
Posted

Hey everyone,

I have a series 1 r33 that I'd like to part with. It's been sitting in the garage since May 2012 when the rego ran out. I had another car. My plan was to fix all the little dents with new panels which I have sourced and mostly done and eventually re-rego it at the end of the year but being a mature age uni student/full time worker/dad has gotten in the way and I'm sort of over it. The odometer reads 148,881 and the engine is stock and I remember the lifters being a bit noisy but apart from that it was strong. Clutch will need replacing but gearbox is awesome along with shockers, diff etc. I never did the 100,000 km service, because I was young, stupid and had no money (please don't lecture me). It's never hit a valve or anything though. Never blew oil, white smoke, never dropped water or oil. Really good car to me. Has a hole cut for front mount but shouldn't be a problem for RWC because no airbag sensors. The photos show the car with 18" wheels, it will be sold with the stock wheels and no exhaust from the cat, as I don't own the exhaust. There remains one dent and paint chip on rear left quarter panel where some idiot backed into it and drove off. The photos show no door on the drivers side but I have a new one and will reassemble before handover.

No rego obviously it'll have to be towed or driven on UVP.

I dont know what to ask for it, I've sourced and spent $2,000 on new parts in last 12 months. Have genuine Nissan water pump and timing belt to go with it.

$5,000- throw me an offer. Car is located Frankston South

post-127600-0-99624600-1403855221_thumb.jpg

post-127600-0-66431500-1403855232_thumb.jpg

post-127600-0-17370200-1403855246_thumb.jpg

post-127600-0-04141400-1403855256_thumb.jpg

post-127600-0-16012200-1403855300_thumb.jpg

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/444928-r33-series-1/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...