Jump to content
SAU Community

Recommended Posts

For sale or swap is my 2008 Mitsubishi Triton ML Olympic edition. 57,000km's.

PRICE DROP - $25,000 NEG for cash. Will swap for a built GTR or late model cars around the 25-30k mark.


3.2L TD manual 4x4. The Olympic edition has all the upgraded features such as leather interior, electric rear windscreen, upgraded wheels, tub liner, etc, etc.

This is the 3.2L, not the under specced 2.5. It's got a great deal of torque and runs brilliantly.

This vehicle is in immaculate condition (the engine bay is dirty, but still good enough to eat off) having only travelled 57,000km's. In that time it's been logbook serviced its entire life.

There's not much that I can really say about this rig that it doesn't say for itself. It drives perfectly, as it should, it's good on fuel and it's a pleasure to drive.

Tow bar
Tub liner
Electric rear window
Perfect leather interior without a single mark
6 stacker CD player
Canopy
Cruise control
Plenty of other features

Triton1_zpse668bf54.jpg

Triton2_zpsf8d87e38.jpg

Triton3_zps0daa41cb.jpg

Triton6_zpsa9658539.jpg

Triton4_zps9689855a.jpg

Triton5_zps38f529ec.jpg

Triton7_zps38bba9c7.jpg

Triton9_zps2e97225a.jpg

Triton8_zps1b3ff9cd.jpg



The price is $25,000 negotiable for cash (dropped from 27). Will consider swaps around 25-30k, swaps for lesser value cars and cash my way could be considered as well.

The only older cars I'd consider in a trade would be an R32/3 GTR, an FD RX7, supra, etc.

Would consider swaps for VE SS utes (6 speed manual only), FG XR6T and XR8 utes, again, manual only.


Would also consider swaps for anything worth 30 odd. A road bike with cash my way would be ok, too...

Can put cash your way for the right deal.

The car is located in South Brisbane and will be sold with rego and a RWC.

Text Trent on 0401029817

Link to comment
https://www.sau.com.au/forums/topic/449806-2008-triton-lux-spec-fs-or-swap-gtr/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...