Jump to content
SAU Community

Recommended Posts

spaz moment, the 235/40 compared to the 45, this will increase spedo reading yes?

i know only by likr 3-4% but i have a 10% speedo error (always reading to high) anyway

Edited by GH05T

The higher profile will make the car go faster than the speedo is reading, so if your speedo currently reads higher than you're actually doing, it will correct this somewhat...but rather negligible as you say.

Let's not use confusing terms that could be interpreted differently.

Speedo runs off the gearbox output shaft, so it takes its reading based solely on engine rpm and the gear selected, irrespective of what's happening at the tyres and diff. Therefore, 2000rpm in 5th will always make the speedo read the same speed (say ~80km/h) no matter what size tyres or diff ratio you have.

Increase your tyre diameter and the vehicle physically goes faster but the speedo reading stays the same. So if your speedo reads high, putting on larger tyres will make it more accurate. If it reads low, putting on larger tyres will make it more inaccurate.

Manufacturers usually calibrate the speedo to the standard tyre diameter and make it read a little bit high so that they aren't responsible for people's speeding fines.

  • 2 weeks later...
  • 2 weeks later...

received the tires, unfortunately i stuffed up the tire speed calculation (yep did it backwards in my head....derp).
my speedo error reads to high already, the new diameter for my wheels means it will now read higher again not lower so they really dont suit which sucks.

still unfitted
which sucks cos the tread pattern looks so nice

re listed in sa :P

http://www.sau.com.au/forums/index.php?app=forums&module=post&section=post&do=new_post&f=12


Edited by GH05T

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I have been wondering if this is as simple as a voltage issue with the battery. Even on a charger, I can’t seem to get it over 11.8V on the terminals.    Unless the alternator has failed as well, that wouldn’t cause it to die in the middle of driving though. 
    • I’ll give this a shot next time I’m able to wrench on it.    I was able to get my hands on a Haltech Nexus, so that should help with some of the more bizarre troubleshooting. Make sure the CAS is actually sending signal and will be able to set the proper dwell on the R35 coils.    I’ve checked power/grounds/signals at the CAS, ignitor, and plugs and it was all there. Granted this was static with ignition on, not cranking.    I also plan on swapping out the fuel filter and throwing on a fuel pressure gauge at the rail just to confirm I’m getting the correct pressure at the rail. 43psi if I recall correctly. 
    • The attached document is fine. I just downloaded & opened it.
    • Hello, sorry for being late to join the discussion, but my clock just died on me.   Ive tried to look at Michaels digital clock repair.docx and it doesnt work maybe the file has expired.   Please let me know if you can re upload it or take some youtube videos to show us how to get the clock installed? thanks
    • I thought that might be the case, thats what I'll start saving for. Thanks for the info 
×
×
  • Create New...