Jump to content
SAU Community

Recommended Posts

Ha ha I'm at work. Will take it easy the next few days. Eating the curry of burning irony in sandwiches for smoko .



OUCH

Blistered up yet?

Amazingly looks pretty good today. Did 1 hour of cold water on off till the heat disappeared. Wrapped in sterile cloth and glad wrap. Nurse said just put antiseptic on for 5 minutes then pat clean keep re laying dressing.
10 hours and I'm done

At least it won't take long to roll the walls

At it again I see! I did our front lounge and the office/kids rooms with floorboards. Cut the edges in with a little rolling edges thing was way easier than tape and brush. I rolled the walls with a long extension on the roller and a halogen light pointing on the wall with 2 pedestal fans running in the room. Was way easier to see from standing back with the long extension pole and light in the room, was colder weather like now so fans and airflow helped the paint dry alot. Stained the timber skirtings in Japan black and cut the shape for a butt up not mitres with a coping saw. Re-done the ceiling first when the floor was concrete with drop sheets. Used the ceiling paint that goes on pink and dries white. Way easier too see. Not a doubt in my mind you've done a trick job!! Animal:-)
Evening all!
mega RB ideas and turbo's filling the grey matter? Seen a insane Supra at coffee and cars. 5" turbo lagged ali lobsterback and 5" s/s dump pipe. It was mega tidy was going to get some pics but the guy was leaving.



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...