Jump to content
SAU Community

Recommended Posts

Hello

I have put a RB25 turbo onto my RB20 DET motor. It has a HKS actuator on it. I didnt want to have to tap a nipple into my pipe before the turbo so I tapped a nipple into the compressor housing, the same as it is set up on the RB20 turbo.

Will this work fine or should I tape a nipple into the pipe before the turbo?

I searched and found both ways mentioned. Also when I set up a boost controller for this, I set up normally as far connection as it is done for the rb20? Just want to get the best out of it.

Edited by yoshiii335

compressor housing should be fine, especially if you tapped it in a similar spot to the RB20 turbo. although I think you mean the pipe "after" the turbo not before it. Before the turbo, you have the rubber pipe going between the AFM and turbo.

compressor housing should be fine, especially if you tapped it in a similar spot to the RB20 turbo. although I think you mean the pipe "after" the turbo not before it. Before the turbo, you have the rubber pipe going between the AFM and turbo.

Fine.

Cool Thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...