Cas Rebuild

[Ruthr33]

Hey, got a quiet knocking noise from the front and sometimes a miss fire on idle.

Suspected timing belt too loose cause I forgot to turn the engine twice before setting the tension. So I've pulled it apart, and I found the cas bearing sounds stuffed. Can I rebuild it? I would buy a new one but I live in broome, 2 weeks wait for anything, For sake of a $4 bearing I'll give it a go.

[Ruthr33]

Got to here. Do and how do I knock the pin out to replace the bearing?

Is there a bearing in the back? Still sounds crunchy when I spin it. How do I get there?

[Ruthr33]

3 hours of searching and found it.

Aem electronics have a rebuild page..

Needed to take the Mitsubishi rubber out and bang the shaft out from there.

[XGTRX]

This may help

https://www.google.com.au/url?sa=t&source=web&rct=j&url=http://aemelectronics.com/files/instructions/30-8761%2520CAS%2520Trigger%2520Disc.pdf&ved=0ahUKEwi-xuju7YDKAhXhLaYKHX64AkMQFggZMAA&usg=AFQjCNHbiWFjZihxmWyjh9cv1hJo_kjncA

I used this guide when I did mine.

Edited December 29, 2015 by XGTRX

[Ruthr33]

Yeh that's the one I looked at. Thanks mate.

Anyways because I'm a bull at a gate I've taken the back Bung off and replaced and sprayed it with canola oil, put the cas back in and fired it up with no timing gun just ruff marks. No pump belt ac belt or power steer belt.. And guess what. The knock has gone. Brilliant. Still gonna change the bearing tho. At least I know that was the problem.

[XGTRX]

Canola oil. He he

[SkudR33]

Amazing! Thanks for sharing!

[89CAL]

That pin through the shaft is sold as. I tried knocking one out of my old noisey CAS and it wouldn't budge at all