Jump to content
SAU Community

Recommended Posts

Hey guys

A mate just bought a 32 with a RB25 from a 33 running on a PowerFC. it runs and drives but has a few little issues they we need some help with.

When starting cold or hot it takes 2-3 turns of the key for it to actually start, 1st time u could crank forever and it won't start, 2nd crank it will stumble after a while, 3rd it starts up just fine

Sometimes when it's hot and restarted a few mins later it will start first go

It runs rich as f***, huge black clouds before boost and as u let off, also has huge orange fireballs as u let off from full throttle

Has very bad fuel economy

Has Z32 AFM and been told aftermarket injectors (can I get info on standard injectors so I can double check)

Input and help is greatly appreciated

Dont really wanna pay for a full retune if it's something simple

Link to comment
https://www.sau.com.au/forums/topic/465260-rb25det-powerfc-issues/
Share on other sites

You cannot hope to make a standard ECU run with a Z32 and bigger injectors. The only way it could possibly work is if the relative change from stock on both the AFM and the injectors was exactly the same. Chances of that are pretty bloody small.

Best option is to take it to someone who can do the obvious stuff, like measure the fuel pressure when it's on load, put a HC or laptop on it and see WTF is going on when it is trying to run and trying to start. Which means a trip to a tuner, with minimum cost being a little time and maximum cost being a full retune + repairs if something is stuffed.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
    • Yeah, I don't believe the M35 uses a deadhead system.
    • Have you done your thinking backwards? 3 bar, 43.5 psi pressure drop being the presumed specification for an injector, means you need 3 bar upstream when they are firing into atmospheric pressure, and more upstream pressure than that when on boost (you add your boost to your rail pressure to maintain 3 bar across the injector) and you need..... less pressure upstream when you have vacuum in the manifold. So, presuming that you're idling at -10 psi, then you only need ~23 psi in the rail. I realise that I did not need to say all of that to you specifically Matt, once you'd realised your mistake. It's mostly there for complete clarity for others.
    • Have you reached out to the guys at Spool Imports? They are a Ross dealer, I can imagine they would have the rings just sitting on the shelf (I could be wrong).  
×
×
  • Create New...