Jump to content
SAU Community

Recommended Posts

R33 GTR 36k

Hey all, im trying to sell my R33 GTR

Full rebuild
87mm cp Pistons
Manly rods
Acl mains
tomie cams 10.8m lift
Tomie cam gears
Tomie head studs
Tomie valve springs
Port and polish
New valves and sleeves
1000cc injectors
G reedy fuel rail
Speed flow fittings and braided fuel lines
Bosch 040 fuel pump
Tomie hi flow oil pump
ATI Dampner
Apexi power fc
6 boost ceramic coated turbo manifold
Gt4088r Garrett turbo
50mm external waste gate
Larger 3inch intercooler
Hks blow of valve
3.5inch exhaust stainless nissmo
E85
Reco gear box with exceedy twin plate clutch
19inch wheels
Fresh respray
Just been dynoed on 17-18psi for run in tune just under 500 hp

thanks

 

Link to comment
https://www.sau.com.au/forums/topic/468540-r33-gtr-36k/
Share on other sites

put a proper ad up, linking to elsewhere is lazy,

also your apparently asking SAU for $2k more than whats on the add? where is the love man.... where is the love?

Link to comment
https://www.sau.com.au/forums/topic/468540-r33-gtr-36k/#findComment-7804379
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just trying to get my head around this. At 5psi of boost, you turn on your wmi pump, and then you're using a 3000cc injector, to allow flow upto the actual engine, where you have your 6x200cc injectors and a 500cc injector. If the above is correct, what advantage are you obtaining by having the 3000cc injector blocking flow, is this just incase a line breaks between that injector and the motor you can stop flow immediately? Or are the 6x200cc and 500cc less injectors and just spray nozzle?
    • Welcome! New member myself, but I had an R33 back in 2002. Best advice I could give, based on my experience: if you're running the factory turbo, be very conservative with boost. I made the mistake of just fiddling around with the boost controller and cranking the boost for fun, and the end result was my intake pipes popping off frequently from the constant deluge of oil that was being blown into the recirc by the stressed-out turbo, which itself was siphoning oil from the engine and farting it out both sides of its centre bearing (or something to that effect). If I could do it all again, I would have gotten a new turbo and had a tune dialled in professionally and then just left it alone! Funny you mention the metal shavings in the gearbox, as I had the same thing - the probe plug (magnetic drain plug, essentially) would come out caked with shavings. At least it was doing its job. Not sure if that's just sacrificial wear and part of the deal, or if my gearbox was shagged, but I wasn't abusing it. Enjoy the R33 - they're a dying breed, and if they weren't $35k+ on CarSales in Queensland, I might have picked up one of those again, instead of the 370GT I own now (though I'm loving the 370GT, that big 3.7L V6 just hits different).
    • Howdy folks. I owned an R33 back in 2002, which was thoroughly beyond my capacity (financially speaking) to maintain/insure, so we parted ways in 2004. Fast forward 21 years (to literally yesterday, in fact) and I'm now the proud owner of a 2007 V36 370GT. I'm happily surprised by how much power the VQ37VHR makes, compared to the RB25DET, considering the latter is turbocharged. I had planned to add a turbo at some point but I'm on the fence about whether I'll even need it (though I do love the sudden onset of extra torque). Any other 370GT owners around the traps, I'd love to hear about your experiences with this car (good and bad).
    • Perhaps the answer is... more jacks!* *proper jacks must be used.  
    • I NEVER think about using a scissor jack unless there is absolutely no other alternative. f**king things are dangerous, annoying and stupid.
×
×
  • Create New...