Jump to content
SAU Community

Recommended Posts

was looking at autobarn today and they sell these carpeted 6x9 speaker boxes that sit on your rear parcel tray.... sorta the same as a sub box but alot smaller....

they are around $70 a pair and im thinking i probably could make some cheaper then that....

would anyone have any measurmants and instructions on how to make a good style of box.... when sat in properly the speaker sorta angles up towards the roof a bit.....

any help/tips would be greatly appreciated.....

:(

Link to comment
https://www.sau.com.au/forums/topic/47686-6x9-speaker-boxes/
Share on other sites

  • 4 weeks later...

no point in low passing 6x9's if you have a sub...mine atm are running normal (no high/low pass) along with my sub, sounds pretty good. with my new splits up the front it sounds a hell of a lot better, but my rear speakers are nothing special.

i didnt know that 6x9's were made like subs, by that i mean to run in sealed/free air...can you port/bandpass them aswell for something different?

Link to comment
https://www.sau.com.au/forums/topic/47686-6x9-speaker-boxes/#findComment-991345
Share on other sites

  • 8 months later...

I'll say it again; the acoustic suspension of 'most' 6x9s is not designed to run in sealed enclosures. The result is that you will not attain optimum bass at best and you'll damage the speaker at worst. :P

On the flipside (once they're installed correctly) and for those of you doubting the bass output of 6x9s, remember the bottom (main) cone is 6x9". That is only marginally less surface area than an 8" subwoofer so they can thump quite hard..

I'll say it again; the acoustic suspension of 'most' 6x9s is not designed to run in sealed enclosures. The result is that you will not attain optimum bass at best and you'll damage the speaker at worst. :(

On the flipside (once they're installed correctly) and for those of you doubting the bass output of 6x9s, remember the bottom (main) cone is 6x9". That is only marginally less surface area than an 8" subwoofer so they can thump quite hard..

Yea my first system i had 6X9's amped in the rear parcell shelf with the low pass filter and running around 50hz at the time and they produced some pretty good bass for speakers that were $100. But you can't go past a sub for convential bass and its a lot tighter, easier to tune and better quality sound is my 2cents. Good set of splits tuned right and a sub in the rear, no real need for rear speakers is there. The sound of them is shooting up and from behind you, your ears face forward when your in the car (unless there is something we dont all know about :wassup: ) so unless you were to fade them to the front more and just run them as a high pass i can't really see the need for them.

But in saying that you do what suits you and what you like the sound of, its your system and thats what counts at the end of the day. :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...