Jump to content
SAU Community

Recommended Posts

You'll find that for R33s at least, there isn't much cost advantage to importing over buying locally (at least privately).

You'll find there is a saving over the price from a dealer's markup.

You'll have an opportunity to select from a greater range of examples by choosing to import.

if ur looking for GTST

i would suggest buying them privately locally

would save you time as transport and compliance takes a while and the days drag on by for those that know the wait

cost saving will be very little if any also due to current low prices already

you can find great examples of r33s locally, both modded and stock

r33 GTRs maybe worth importing i guess if the price is good but still a number of good examples out already

i wouldnt suggest buyin it from dealer unless u really want the warranty coz their prices are usually inflated

i wouldnt buy from dealer either car

i wouldnt import a gtr (too many things can be stuffed that u cant check)

for a gtst buy it locally if u are looking at a series 1, for a series two u would save more (lots of owner seem to try and sell them for ageees at high prices and eventually give in)

but i still would buy locally because u can see how the car is and u dont save that much..unless u get ripped off.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The oil pressure sensor for logging, does it happen to be the one that was slowly breaking out of the oil block? If it is,I would be ignoring your logs. You had a leak at the sensor which would mean it can't read accurately. It's a small hole at the sensor, and you had a small hole just before it, meaning you could have lost significant pressure reading.   As for brakes, if it's just fluid getting old, you won't necessarily end up with air sitting in the line. Bleed a shit tonne of fluid through so you effectively replace it and go again. Oh and, pay close attention to the pressure gauge while on track!
    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
×
×
  • Create New...