Jump to content
SAU Community

Sunshine People '05 & Summadayze '05


Recommended Posts

  • Replies 115
  • Created
  • Last Reply

Top Posters In This Topic

two tribes! awesome... first day rave so it looks like...

not the bestest lineup ever, but good names, Rank 1, Push, Signum, Bukem...

Adrian count me in for 2 tickets (so far), will let you know if i need more...

Y@$ (from Japan)

yes mullberry is on swan and its not to bad to drive there....

nah i have mikes bday and other stuff i wanna do.. sick of wasting money on events and then being stuffed until i get paid again... :(

yeah, just saw that prodigy will be @ two tribes. . haven't seen them since 1993 so I might go along to it :D

but they were much better back then, they hadn't sold out :D

but the girlfriend wants to see IM, they're her favourite group, so its probably one or the other for me :rofl:

haha well two tribes is gonna be a day rave so you can make it for sure :)

bentley? which direction from bentley though? 40 mins drive from Perth and you lose reception .. haha jk... :)

40mins from the centre of tokyo on an unlucky day would get you around the block... hehe also jk...

  • 2 weeks later...



  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...