Jump to content
SAU Community

Recommended Posts

Hi there I've just hooked up an amp using the rear speaker inputs rather than RCA input.  There is a bit of hiss when volume is low.  Is this normal and will unning off RCA's help.

Thanks

Ben

Hiss, i hate that, especially when passengers notice it and go, 'whats that sound'

Anywhos... i had this problem and found that my wires running from the head unit to the amp were running with power cables. When running cables try to isolate them from other cables, esp. powered ones, as much as possible. this will minimise hiss.

Hopefully you can upgrade and employ some RCAs, and dont go cheap on the RCA's either. get some shielded ones.

If you were like me and still had a slight hiss when all was hooked up, try using a filter on the inputs at the amp end, or Run a wire from the grounding point of your amp back to the grounding point of your headunit. This worked for me.

Link to comment
https://www.sau.com.au/forums/topic/59489-amplifier-hiss/#findComment-1135089
Share on other sites

Running speaker lines next to power cables will have little effect on "hiss".

Running RCA's next to power cables runs you the rish of introducing "alternator whine", which is different to "hiss".

Conclusion: Run RCA's.

Link to comment
https://www.sau.com.au/forums/topic/59489-amplifier-hiss/#findComment-1135259
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...