Jump to content
SAU Community

Recommended Posts

Guest GR33DyMANGO

once the turbo timers on.. couldnt someone get in the car (ie break window etc) then once inside just keep pushing the turbo timer button to the longest amount of time then just keep pushing it??? someone could potentially keep driving until they reach their garage where they strip your car etc....

im sure it happened to my friend as a joke... but his was just driven round the corner.

hehe yeh good point but u can disable that with a screwdriver and a bit of effort.

Remember the simpsons ep where Mr Burns gives Bart the ferrari and he cant even see over the wheel. ahh i loved that ep:lol:

  • 2 years later...

with my car being an auto u cant get the keys out of the ignition unless its in park and cant change gears without the keys being in the ignition. hell u cant go into reverse unless u put ure foot onto the brake.....

but even still if the people can find ure TT then they have direct acces to ure ignition wires and can just satart it coz most immobilizers dont activate till 30 secs after the car stops, unless u have ure alarm wired in to allow it....

Bambam when you say they "searched" your car what exactly did they do and where did they look?:eek1:

Searching Persons without a Warrant

The Police Powers and Responsibilities Act permits police officers to search persons without a warrant.

The authority of the police to search a person without a warrant is dependent upon the existence of a ‘prescribed circumstance’. If a police officer reasonably suspects that a ‘prescribed circumstance’ exists. The prescribed circumstances in which an officer may search a person without a warrant includes circumstances in which the person is reasonably suspected to be in possession of:

a weapon, knife or explosive;

an item which the person intends to use to cause harm to any person;

a dangerous drug;

stolen, illegally obtained or tainted property;

evidence of the commission of an offence punishable by a minimum of seven (7) years imprisonment, which the police officer reasonably suspects may be concealed or destroyed if a search is not conducted;

an implement of housebreaking, motor vehicle theft or drug use.

Searching Vehicles without a Warrant

An identical set of rules apply to police searches of vehicles without a search warrant. A police officer may stop and search a vehicle, together with anything in it, if any of the above ‘prescribed circumstances’ exist.

When searching a vehicle, the police are allowed to enter, re-enter and stay in the vehicle as often, and for as long, as is necessary to properly carry out their search. The police also have the power to move a vehicle to an appropriate place for a search, in particular if it is impracticable to search the vehicle where stopped.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...