Jump to content
SAU Community

Recommended Posts

heya pplz

a few of us are heading to the Ambar to watch Pendulum / El Hornet play...

Starts at 10pm and its $10 @ the door.. (pretty cheap)

info here inthemix.com details

hopefully see some of you there :)

-pie

Link to comment
https://www.sau.com.au/forums/topic/64257-pendulum-el-hornet-tonight-ambar/
Share on other sites

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

yeh i think its that dude...

it will be the last time Pendulum play in AUS for a while.. they are heading back to the UK :)

stove and myself from here are going and a few of our mates.

hope to see yas there :rofl:

-pie

yeah kick him the balls for me, call him rude, and tell the prick to ring me!

awww he didnt return your call the next day denver? He was just using you for your body you know :)

its twisted distorted evil amen mashup mayhem darkstep jungle

nit skitz is hardcore right ? i love him . he is bangin dog .  

run to paradise remix is soooo cool !

ohh yea!

:bonk:

that mix you posted is well wikked ;) anymore stuff like that? i love it hard and dark.... music that is.




  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...