Jump to content
SAU Community

Recommended Posts

I had a similar problem that went away when it warmed up.

The problem was a leak in the inlet manifold gasket. When it warmed up, and everything expanded the leak sealed up and it ran fine.

Wasnt untill the gasket blew out completely that I found the problem.

Link to comment
https://www.sau.com.au/forums/topic/64905-steroided-rex/#findComment-1216564
Share on other sites

haha sterioded rexxy means it aient kool for a skyline to sound like that!!!! is missing and sounding like a rexxy

no it only just happened now

only for a few mins wen its cold but its enough to do my head in!!!

QUOTE=600hp]I'm not sure what you mean by it goes like a rexy, does this mean it sounds crap or it gets off the line fast?

thanks.

also has this always happened since you have the car.

Link to comment
https://www.sau.com.au/forums/topic/64905-steroided-rex/#findComment-1221765
Share on other sites

Mine does that every now and then too.

Runs on one cylinder down.

Does sound a lot like a rex.

Mine goes away after a couple of revs, or just by itself after 10 seconds or so.

Happens very occasionally to me, and at very randow times, hot/cold whenever.

Link to comment
https://www.sau.com.au/forums/topic/64905-steroided-rex/#findComment-1227245
Share on other sites

Mine was doing the same thing when cold because the ecu thought the car hadn't warmed up yet so was pulling heaps of timing out... it sucked... would come good the exact same place on the way to and from work... weird

so wat can do 2 fix this prob???

if i dothe ecu codes test will it bring up an error code???

thanks 4 da help much appreciated

Link to comment
https://www.sau.com.au/forums/topic/64905-steroided-rex/#findComment-1227731
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Make sure you use the spherical bushes** on the lower arms, ifyou do that. ** at least, if not the whole replacement lower arm.
    • The tap for coolant flow control will be stuck open. It's not just the air door motor that dies.
    • Not really, but the heater box is pretty simple mechanically....if the door is one way the air bypasses the heater core and if it is the other way it goes through it for warm air.  If you are sure the actuator you moved manually is for the heater mix (there would also be one for output air direction) then I'd take the heater box out and see what is happening (you'll have to regass and re-coolant the systems afterwards) BTW pp724 onwards from the GTR workshop manual cover the system in good detail, it is probably worth checking. I think the IAT sensor might be a problem electrically for getting cold (if you got 24 error code not -24 it thinks the incoming air is -50c) and it covers how to test the sensor (although most likely it is either not plugged in or a wire is damaged)
    • Use the GKTech subframe bush and bring your subframe 10mm closer to the chassis. You'll need to fix an exhaust hanger to suit. One of the best mods I've done.
    • You'd really have to pull it apart further to know, it least you can be confident that the one heading to the back is not connected any more. There was once a ground on the shifter seal mount too, your head unit issue could be that simple
×
×
  • Create New...