Jump to content
SAU Community

Recommended Posts

i need 12v to turn on gauges in the cabin when i flick on the

headlights/highbeam. i've done a search and heard that i can tap into the

fuse - but apparantly the fuse is in the back for the 33s i dont exactly want to run wires all teh way to the back and then back to the front.

i can do the cigarette lighter too - but then they'd be on all the time, a switch is

possible... but

was thinking of tapping it into the loom - but not sure which wires to splice

into. any help wud be much appreciated, and pictures wud be great

Cheers.

Eugene

Link to comment
https://www.sau.com.au/forums/topic/65144-tapping-into-headlight-power/
Share on other sites

Where are you guages going? Why dont you just find the light switch wires under the dash or near the steering wheel (i did this) Its not hard to do at all, just get a test light, turn on and off your lights and parkers until you find a wire that gets power when they are on, and loses it when they are off. Quite easy to split the wire and solder into it.

But if your guages are going into the bottom din spot into a shelf then the cigerete lighter mite be a little bit easier :rolleyes:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bit of a pity we don't have good images of the back/front of the PCB ~ that said, I found a YT vid of a teardown to replace dicky clock switches, and got enough of a glimpse to realize this PCB is the front-end to a connected to what I'll call PCBA, and as such this is all digital on this PCB..ergo, battery voltage probably doesn't make an appearance here ; that is, I'd expect them to do something on PCBA wrt power conditioning for the adjustment/display/switch PCB.... ....given what's transpired..ie; some permutation of 12vdc on a 5vdc with or without correct polarity...would explain why the zener said "no" and exploded. The transistor Q5 (M33) is likely to be a digital switching transistor...that is, package has builtin bias resistors to ensure it saturates as soon as base threshold voltage is reached (minimal rise/fall time)....and wrt the question 'what else could've fried?' ....well, I know there's an MCU on this board (display, I/O at a guess), and you hope they isolated it from this scenario...I got my crayons out, it looks a bit like this...   ...not a lot to see, or rather, everything you'd like to see disappears down a via to the other side...base drive for the transistor comes from somewhere else, what this transistor is switching is somewhere else...but the zener circuit is exclusive to all this ~ it's providing a set voltage (current limited by the 1K3 resistor R19)...and disappears somewhere else down the via I marked V out ; if the errant voltage 'jumped' the diode in the millisecond before it exploded, whatever that V out via feeds may have seen a spike... ....I'll just imagine that Q5 was switched off at the time, thus no damage should've been done....but whatever that zener feeds has to be checked... HTH
    • I think Fitmit had some, have a look on there (theyre Australian as well)
    • Hah, fair enough! But if you learn with this one you can drive any other OEM manual. No modern luxury features like auto rev-matching or hillstart assist to give you a false sense of confidence. And a heavy car with not that much torque so it stalls easily. 
    • Actually, I'd say all three are the automatic option. Just the different trim levels. The manual would be RSFS, no? 
×
×
  • Create New...