Jump to content
SAU Community

Recommended Posts

Hey.

Im selling my wheels now as i will be selling my R33 with just stockers on....

Ok they are GENUINE japanese Enkei wheels which arnt avaliable in Australia and must be imported if wanted. Brand new they are worth over 5 grand without tires. They are very light weight and sizes are 17X9 for front and 17X10 at the rear. Tyres are 1 month old at the fron and size is 235/45/17 and about 5 months old at the rear and are Khumo Supra 255/40/17.

I was told that these wheels are 3 peice forged wheels and are light weight and very strong. Type of wheels they use in japan for track and drift cars etc.

They are a very hot looking wheel and are white and some angles have a blue pearl to them.

one wheel has a little bit of gutter rash but apart from that there in mainly good condition. ill put up pics of each once i get some time.

Stud pattern is 5X114.3 and would suit deffinatly an R33 GTST but they should fit a R32, R34, 200sx, 300zx, ford :wassup: haha Please correct me if they wouldnt fit.....

Asking $1500.... Bargin...... $900 in tyres alone so really the rims are only $600....

Once again they are a very nice wheel and look hot on my skyline....

osiris23-PC030040.JPG

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...