Jump to content
SAU Community

Fuel pressure regulator CHEAP!!!

boosted_32
 Share

Recommended Posts

boosted_32 Proficient

boosted_32

Posted
Posted

FOR ALL CARS TURBO OR N/A

This FUEL PRESSURE REGULATOR can provide precise consistent boost as much as twice the factory fuel flow. From your dedicate engine tuning, the FPR can boost from 20PSI to 85PSI, or as much as your fuel pump can sustained

This unit is capable of supporting enough fuel flow for engines in excess of 850 horsepower, and is ideal for forced-induction engines since it is boost dependent (1:1 Ratio).

the company who makes this product also supplys Nissan Japan Motosport to fit on there 1000hp godzilla,

This is another thing you need if you want High Boost All the time!!

the only competitor to this brand is Malpase

this is anodized and comes with a 24 month Warranty.

RRP of $289AUD

Hose clamps and installation instructions are Included!

$150

Link to comment
https://www.sau.com.au/forums/topic/69584-fuel-pressure-regulator-cheap/
Share on other sites
  • 3 weeks later...
boosted_32 Proficient

boosted_32

Posted
  • Author
Posted
So this thing is a must for modified cars?

So just a fuel pump is not enough?

Fuel regs hold a steady pressure through your fuel rail and because you can adjust the pressure you can work you injectors harder if you don’t want to change your standard injectors if your on a budget

  • 4 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Komdotkom
      R32 Gtst - Track Car

      By Komdotkom · Posted

      Good luck on the weekend mate
    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...