Jump to content
SAU Community

Recommended Posts

Hey guys,

I have jsut had huge scare other day on the way to work, i was taking off at lights, and as i was listening to a favorite tune, had music up, and i didnt' realise that the rear wheels must have started to spin, i went to indicate left to get in my lane to turn off, and was entering teh nundah bypass tunnel, and as i tryed to straighten up to comtinue as normal, the car just kept on vearing towards the left right 4 the wall, so i quickly swung it over to pull it away and over corected and did 180 and teh arse end was heading straight for otehr side of tunnel,

never been so scared in my life.

i have car that it unscratched from this incident but was only like 30cm's away from hitting the wall.

i hate rain.

Just warnign u's how much it changes conditions specially with teh turbo, and keep ya tunes down in the wet too.

thank god it was all ok

Later guys

Robz

Link to comment
https://www.sau.com.au/forums/topic/69889-spun-out-my-r33-a-huge-leason-learnt/
Share on other sites

  • Replies 64
  • Created
  • Last Reply

Top Posters In This Topic

As long as you learnt from the experience dude thats the main thing.

Personally Id be also checking your tyre pressures :P As when your low on air the tyres dont do what they should in the wet. One of mine was only 3psi lower and it was being a wee bit taily, you could even see behind the car one tyre was lower on air.

Also in quiet open areas when its wet, just give it a bit, try find the limits a bit more (yeah skidpan is all well and good, but its not actual road conditions)

Yeah when I first got the car I had it fishtailing (wildly) once when I had to turn into traffic and was blocked by a parked 4wd to see if any cars were coming, eventually I just said "f*** it" and went out into the lane, there was a camry almost on me so I floored it and got round the corner and started fishtailing badly, about 45 degrees one way then the other and with countersteering got it under control.

Basically - don't hit the pedal too hard when you're turning a corner. Robz it happened to you because you were turning into the tunnel, stay off the accelerator until you get straight again and this goes doubly when it is wet.

here you go

some selective copy paste from the WRC rally site

The thinner tyres - typically 135mm wide compared to 205mm gravel and 224mm asphalt tyres - have a wider, more open tread and smaller footprint. They may make the modern generation of low, wide rally cars look slightly gangly, but these dimensions allow the tyres to penetrate the loose snow to reach the harder, more compact base below

yeah, this is half of the reason that turbos and kids don't mix.

Something similar hapened to me many years ago in the wet. Damage was done and a lesson was learned, and it took me many years to shake off my issues with driving in the rain.

I'm glad you've learned your lesson. As Strutto said, go up to mount cotton and do some driver training as it's well worth it. also being able to "cut sick" in a controlled environment should give you some much needed experience so you can identify when your car has lost traction. if the revs and the engine noise don't match what your ass is feeling through the seat then back off. Where a lot of people run into trouble (and I know i did in the past) is when you put your foot down and the wheels start spinning unbeknowns to you and your brain thinks the car isn't responding, so you put your foot into it more. Tail end comes out then you freak out, slam your foot on the brakes (locking them) and wind the steering wheel to full lock. Once you do this you're pretty much screwed and all you can really do is hold on and pray.

Either that or boost it before the apex of a corner in the wet. It's just way too easy to do yourself permanent damage in a turbo in the wet, especially on skinny tyres.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...