Jump to content
SAU Community

Recommended Posts

  • Replies 99
  • Created
  • Last Reply

Top Posters In This Topic

I'm pretty sure the 0.400s is the time difference between the lights, and if you are below this, then you have reacted before the green appears, since it hasn't been 0.400s after the previous orange

also we can react quicker than 0.400s since I tried it once at school, with dropping a ruler and measuring the distance it drops to determine your reaction time...worked out quicker than 0.4s

I'll be down there on Wednesday night, so I will ask the officials, just to clarify what the ruling is. I thought the ET stands as is, but I could be wrong, it happened once before.

Hey Macka, want to help me build a drag Capri, I'm sure with $100,000 we could getit into the 13's, what do you reckon? Did I misspell that, is it Capri or Crapi, I forget.:bahaha:

See'ya

:burnout:

Originally posted by PSIKO

I'm pretty sure the 0.400s is the time difference between the lights, and if you are below this, then you have reacted before the green appears, since it hasn't been 0.400s after the previous orange

also we can react quicker than 0.400s since I tried it once at school, with dropping a ruler and measuring the distance it drops to determine your reaction time...worked out quicker than 0.4s

you might, but try getting the car to move faster than that its not possible.

imho as an onlooker but someone who reads mags etc.

The reaction time is incorrectly named and should be called anticipation time. As the oranges blink at .400 sec apart and the green is .400 after the last orange then it is possible by counting in your head to leave at the exact time the green comes on.

The *reaction * time is the time taken from the last orange going out. Obviously if it is under .400 then you left before the green.

It is operated by the wheels breaking the staging beam and you have a tiny bit of leeway between pre stage and stage lights.

You can *deep stage * ie. very close to the breakout light which will give a slightly quicker reaction time but run the risk of leaving too soon.

The ET is the time from you breaking the beam and finishing at the end so in theory you could sit at the line after it's gone green for 10secs and still get an ET the same as the guy who left on the green.

A TRUE reaction time is with no warning or any specific timing ( ie like a Touring car race ) the lights would come on while you are at the line.

As a matter of interest, using the old light comes on , press the the buzzer test, guys like Sir Jack Brabham , Stirling Moss and Jackie Stewart had reaction times around .200 - .250 secs which prolly explains why they were so damn good.

yup, like I said but more detail haha :P

you can get your car moving at whatever reaction time you want, there is no scientifically proven fact about it...some cars respond differently due to their internals and of course the drivers abilities

like gtrken said, the light is broken as the wheels go past the beam, you can launch it on one light, or both, but the 0.4s is the time between the lights and will only ever register the r.t when the 2nd light is broken

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...