Jump to content
SAU Community

Recommended Posts

  • Replies 97
  • Created
  • Last Reply

Top Posters In This Topic

  • 3 weeks later...
we MIGHT have it in before DECEMBER cant say how i know i just do.

Was supposed to arrive into the pumps at Selfs Point last month, but the safety team they set up to assess the setup deemed the setup unsatisfactory so we now have to wait a bit longer while they set everything up again to pass the safety inspection.

Oh and 98RON petty will be 2c/L dearer than ordinary 95RON petty :D.

This all came from the manager at Shell North Hobart, so it aint bullshit :D.

Link to comment
https://www.sau.com.au/forums/topic/78592-pulp-98/page/2/#findComment-1527030
Share on other sites

Ive got a Microtech LT-8, thinking about upgrading to an LT-12 but there isn't much difference except more inputs/outputs. oh and the cost factor.

Do you know Paul with the White S4/5 RX7 (think he was at the drags) pretty sure he gets ELF or C16 or something from MOTO sports on Killafaddy Rd, i am pretty sure they get all that stuff in

was your 300rwkw run made just on plain jane 95RON Premo?

Link to comment
https://www.sau.com.au/forums/topic/78592-pulp-98/page/2/#findComment-1528853
Share on other sites

yeh, MOTO get anything you want, I used to get toluene from them. Keen to want to spend that much on petrol though.

Off topic, who you getting to tune it tim? u got a new turbo yet?

Edited by phat_r33
Link to comment
https://www.sau.com.au/forums/topic/78592-pulp-98/page/2/#findComment-1529244
Share on other sites

Went into MOTO today they have 102 octane for about $90 for 20litre drum.  He said they might be getting some 110 octane he will let me know when it arrives.

be good if you could keep us posted about it mate :)

Cheers B

Link to comment
https://www.sau.com.au/forums/topic/78592-pulp-98/page/2/#findComment-1538700
Share on other sites

Yeah let me know how u go with the fuel as well, as it is now gettin to high 300's for a 200L drum of bp ultimate which i use in the gtr and i will also use it in the race car and its gettin fairly expensive for pulp fuel.

cheers matt

Edited by BLUEGTR
Link to comment
https://www.sau.com.au/forums/topic/78592-pulp-98/page/2/#findComment-1540308
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...