Jump to content
SAU Community

Recommended Posts

Hey everyone,

Just recently had the fuel pump fixed in my R30. Thought all the problems would be over. When the pump was not connected to the fuel line, it pumped out petrol. When it is attached to the fuel line it still pumps, but nothing seems to get to the engine. You can see the petrol in the fuel line, just before the fuel filter. I took the filter out, and you can blow through it. What would this be? I don't know much, but it kinda sounds like the pressure isnt big enough or something. If anyone knows or has had this problem, I would be happy to hear about it.

Thanks

Adam

Link to comment
https://www.sau.com.au/forums/topic/79035-fuel-pump-again/
Share on other sites

It sounds like the metal line that runs under the car may be pinched / blocked.

Have a careful look at the condition of the line, from fuel pump to fuel filter. There may be some metal shields in the way - remove them. Spend the 5 minutes to do this properly. What you would be looking for is any sign that the metal line has been crimped (from a rock, jack or the like).

All looks good? Disconnect the hose from the fuel pump and disconnect the fuel filter and blow through the pipe from the engine bay end. First, fuel should run out of the line of its own accord. Blow through the line from the engine bay end, just to be sure. There shouldn't be resistance. If it feels like you are blowing up a balloon, you have your answer. Oh, and it would probably be the reason that you old pump karked it too...

Link to comment
https://www.sau.com.au/forums/topic/79035-fuel-pump-again/#findComment-1442378
Share on other sites

Have you tried with the fuel hose disconnected from the fuel rail?

I recently replaced mine, and it took quite a while to get fuel at the fuel rail. I disconnected the hose from the rail, and had to do several "primes" of the fuel system (just switch ignition to ON, you get that initial 5 sec running of the pump, then OFF / ACC, then back ON).

Link to comment
https://www.sau.com.au/forums/topic/79035-fuel-pump-again/#findComment-1443814
Share on other sites

Hey Guys,

Found out the problem. Had a mate comeover, after scratching our heads for a while :bonk: , we decided to place the pump right near the motor. Anyway it turned out to work. The fuel pump is working, but does not have enough pressure to reach the engine. So have to buy a new fuel pump......

ADAM

Link to comment
https://www.sau.com.au/forums/topic/79035-fuel-pump-again/#findComment-1454409
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just trying to get my head around this. At 5psi of boost, you turn on your wmi pump, and then you're using a 3000cc injector, to allow flow upto the actual engine, where you have your 6x200cc injectors and a 500cc injector. If the above is correct, what advantage are you obtaining by having the 3000cc injector blocking flow, is this just incase a line breaks between that injector and the motor you can stop flow immediately? Or are the 6x200cc and 500cc less injectors and just spray nozzle?
    • Welcome! New member myself, but I had an R33 back in 2002. Best advice I could give, based on my experience: if you're running the factory turbo, be very conservative with boost. I made the mistake of just fiddling around with the boost controller and cranking the boost for fun, and the end result was my intake pipes popping off frequently from the constant deluge of oil that was being blown into the recirc by the stressed-out turbo, which itself was siphoning oil from the engine and farting it out both sides of its centre bearing (or something to that effect). If I could do it all again, I would have gotten a new turbo and had a tune dialled in professionally and then just left it alone! Funny you mention the metal shavings in the gearbox, as I had the same thing - the probe plug (magnetic drain plug, essentially) would come out caked with shavings. At least it was doing its job. Not sure if that's just sacrificial wear and part of the deal, or if my gearbox was shagged, but I wasn't abusing it. Enjoy the R33 - they're a dying breed, and if they weren't $35k+ on CarSales in Queensland, I might have picked up one of those again, instead of the 370GT I own now (though I'm loving the 370GT, that big 3.7L V6 just hits different).
    • Howdy folks. I owned an R33 back in 2002, which was thoroughly beyond my capacity (financially speaking) to maintain/insure, so we parted ways in 2004. Fast forward 21 years (to literally yesterday, in fact) and I'm now the proud owner of a 2007 V36 370GT. I'm happily surprised by how much power the VQ37VHR makes, compared to the RB25DET, considering the latter is turbocharged. I had planned to add a turbo at some point but I'm on the fence about whether I'll even need it (though I do love the sudden onset of extra torque). Any other 370GT owners around the traps, I'd love to hear about your experiences with this car (good and bad).
    • Perhaps the answer is... more jacks!* *proper jacks must be used.  
    • I NEVER think about using a scissor jack unless there is absolutely no other alternative. f**king things are dangerous, annoying and stupid.
×
×
  • Create New...