Jump to content
SAU Community

31 takes 2nd place in nsw drift comp round 3

88silhouette

By 88silhouette,
in New South Wales

 Share

Recommended Posts

88silhouette Grand Master

88silhouette

Posted
Posted

chris easton (redx) once again showed em all the might of the 31. getting 2nd place in the latest initial drift state round.

chris got 2nd in the 1ast round, and was knocked out in the 2nd round, but now currently leads the table.

go the 31!

IMG_5848.jpg

IMG_5849.jpg

IMG_5870.jpg

IMG_5876.jpg

IMG_6018.jpg

IMG_6246.jpg

IMG_6286.jpg

IMG_6299.jpg

Beer Baron Grand Master

Beer Baron

Posted
Posted
sprinter got 1st. yup i know..

3rd was 13.

everyone knows 2nd place is the besy place

bloody sprinter. they are all too fvkcing loud also. get a turbo on it to shut those things up.

for sure, 2nd is the mans position on the podium.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • GTSBoy
      R32 gtr transmission strength, billet plate

      By GTSBoy · Posted

      You're already well into "gearbox is a consumable" territory there. A billet plate will either make it (effectively) 1% stronbger or make it last one more pass. At some point you'll probably tear 3rd gear into small chunks and regret all the life decisions that came before it.
    • dbm7
      forum.r31skylineclub.com down or gone?

      By dbm7 · Posted

      ..and forum.r31skylineclub has been down all week....anyone know why?
    • cosline
      R32 gtr transmission strength, billet plate

      By cosline · Posted

      I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • joshuaho96
      GTX2867R GEN 2 NO OUTPUT FOR BOOST SOLENOID

      By joshuaho96 · Posted

      From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • MBS206
      Nissan Skyline R34(ER34) Front Suspension Noise

      By MBS206 · Posted

      I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
×
×
  • Create New...