Jump to content
SAU Community

Recommended Posts

Hey guys,

Thinking of maybe purchasing an r32 2 or 4 door skyline in the near future. (Finally...after being a long time reader)

Just wondering if anyone knows how hard is it to convert the 4-door (ugly) rear lights to the nicer 2-door ones?

Do i just need to change the boot and rear bar to the 2-door version to accomodate these lights?

If that's the case, count me in the 4-door skyline club. :cheers:

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/80188-r32-4-door-rear-light-conversion/
Share on other sites

Found it! boo yeah!

http://216.239.39.104/translate_c?hl=en&sl...3D%26safe%3Doff

(in jap)

http://www.east-bear.co.jp/aeroparts/skyli...2/tail-kit.html

It's a kit, from East Bear... converts 4 Door Lights > 2 Door Lights...  Now it's up to you to find where it's sold  (tip: give C-Red Tuning a try...)  

EDIT: Oh, and so far as I can tell - it just goes in the original place... no bodywork required!

Thanks for your replies guys,.. they seem to be just tail light covers, which cover the ugly dark bits.

Either than this, can the 2-door taillights be put on with the 2door boot and rear bar?

I was gonna get a carbon boot and vertex rear anyways, so do i just need the taillights?

Same question, different model...

Can R34 sedan tail lights be switched with the coupe tail lights? ive looked in pictures and they look pretty much the same shape, but can it be done? Would be good to have the tail lights without the indicator bar across the bottom.

  • 6 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...