Jump to content
SAU Community

Recommended Posts

Hey guys ready to take the car down the quarter

car has just been converted from auto to manual

auto did 15.2

hopin in the manual to do a low 14 hopefully

see how it goes

i have

FMIC

Apexi AVCR

CES Racing split dump

highflow cat

Full 3inch Exhaust

Set on 8psi and 170rwkw

recently done at FIST

Clutch was still slippin at that stage.

but all sorted

be out tommorrow and i'll tell yas how it goes

at willowbank

12/07/2005

auto also did 166.9 rwkw on 10psi done by APC

And the car has alittle pop at idle cause of spark plugs i think

puttin in v gruves NGKS on the weekend

Hey guys ready to take the car down the quarter  

car has just been converted from auto to manual

auto did 15.2  

hopin in the manual to do a low 14 hopefully  

see how it goes  

i have  

FMIC

Apexi AVCR

CES Racing split dump  

highflow cat  

Full 3inch Exhaust

Set on 8psi and 170rwkw  

recently done at FIST  

Clutch was still slippin at that stage.  

but all sorted  

be out tommorrow and i'll tell yas how it goes  

at willowbank  

12/07/2005

auto also did 166.9 rwkw on 10psi done by APC  

And the car has alittle pop at idle cause of spark plugs i think  

puttin in v gruves NGKS on the weekend

Hey guys best time was a 14.3 with a .8 start

and 1st gear skidded abit and was wheel hoppin a little

my car is real quiet and i let it rev out too far and lost time there between 2nd and 3rd

but other then that, thought it did alright

so it was first when the car was stock as 16.1

with front mount, AVCR, Dump Set on 10psi 15.2

then converted to manual 14.3 set on 8 psi

60 ft time was 2.211

and the reaction time was actually .601

98.35 mph

but yeah i should of let the back tyre pressure down abit

would of gained a bit more traction

and im wanting lowered suspension,

at the moment savin for the power fc aswell

so yeah see how it all goes and take it out again sometime soon

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...