Jump to content
SAU Community

Recommended Posts

Umm im confused why do you care if remax gets free publicity, dont you just work there? That and in this position im worried about much more than just people that have lived in their house a long time and are now worried about being pressured into selling to make way for a new high rise. Not saying I agree with it but i'm sure theres more pressing issues...things such as,i dunno, hooning for example jk. But yea, as far as im concerned none of the people are usually fit to be in office but they are politicians...we need a lawyer to set things straight, seen as this isnt possible, as with everyone else, if he can lower fuel prices he has my vote.

People, I think petrol prices going up isnt an overly bad thing. Interest rates would skyrocket otherwise. But you can all blame it on China, its their fault. They are building effectivly the city of Brisbane every month. A few WA iron ore mines have signed either 10 or 15 year contracts with China. They are just using so much.

i think interest rates should skyrocket :P

its stupid artificially protecting them to such an extend that they are these days... it leads to other instability in the longer term, and is unsustainable.

small corrections are healty..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...