Jump to content
SAU Community

Recommended Posts

just spewing coz its got absolutely NO midrange

the hks2530 is known for its midrange torque so there definately must be something causing your turbos not to start pulling and spinning the wheels as soon as you stab on the throttle.

sorry hud let me clarifiy you need to keep the restrictor as it reduces the size of the hole the air has to travel through which increase the pressure holding the wastegate(act) closed ( think about a garden hose when u put your thumb over the end) Ive read that by altering the size of the hole in the restrictor you can change how the turbo ramps up on boost ie make it spool slightly earlier or later( hpi mag did a build up on a jap spec s15 which they did this on) if your missing the restrictor entirely by using pretty blue hosing instead you may get the problem you have as there is not enough pressure holding the wastegate(act) closed

  • 4 months later...

damn so 1 bar @ 4,000rpm is resonsble..? i was looking at the hks line of turbos for my r32 (rb20) was thinking

- GT2835 pro S

- GT-RS

- GT2530 (KAI what the diff with KAI or not??)

was told GT-RS would be laggy get the 2835 pro and i guess there going to shit aswell so might be looking at 2530 now?? anyone have any ideas on what the other 2 would be like??

I remember reading in some post that the new 2530kai is rated higher than the old 2530 in terms of power...old 2530 was 320ps i think and the 2530kai is something like 350-360ps or something like that...try searching here...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...