Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Ken, when the window was stuck in at the factory the glue found it's way into the outer strip & gasket underneath (can't remember the name of the parts sorry). Therefore I had to replace them - there goes an extra $300!!!

Ken - the konis on my car - are they just shocks or coilovers.

BTW - wtf are coilovers? Are they just the springs outside the shocks? Sorry, I'm only a learner, remember?

Originally posted by Micko

Ken, when the window was stuck in at the factory the glue found it's way into the outer strip & gasket underneath (can't remember the name of the parts sorry). Therefore I had to replace them - there goes an extra $300!!!

Ken - the konis on my car - are they just shocks or coilovers.

BTW - wtf are coilovers? Are they just the springs outside the shocks? Sorry, I'm only a learner, remember?

Koni's ??

Did I sell the car with Koni's ??

Cheers

Ken

I reckon if you still had the Buddy Club rims I might have had a shot - I reckon they would look awesome on my car - boss doesn't really apprecaite the polished look.

Those damn panelbeaters must have been grinding near the window cos it has a few burns on the inside - tinting will cover that up though;)

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...