Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

haha its about as similar ot the magna as the toyota lexcen is to the holden commy haha :)

I knew someone that had the plates Magma on the magna thought it was kinda funky so i call them magmas now haha :P

he's getting a toyota camry V6 soon - he keeps asking me when its coming but i dont manage the fleet anymore so how the fark would i know (wish i did :) ) but i'll break it in for him hehe he's got they gay silver leaf (mint) colour tho - yuk!

gonna have to get the ebc dyno tuned

lovely 1 bar last night due to the cold wheather and boost was still rising. (thank goodness for the warning level thingy)

today boost still rising at 6700rpm was at 13.5 psi but had 11 buy 3500rpm

r well wait till the pfc gets done?

paulie yours goes to the set value and stays there right?

thought about mid afternoon chockie too but after all the junk food ate on weekend i decided against it! I lurve cherry liqour chockies they are an orgasim for the mouth haha :) their my anti depressants whenever im really sad!

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...