Jump to content
SAU Community

Recommended Posts

  • Replies 79
  • Created
  • Last Reply

Top Posters In This Topic

See what I mean about confusing ;)

There is a NISMO kit and a seperate Nissan Motorsport kit which are 2  different kits. The Nissan Kit fitted to yours was available as an add-on when you bought your car (like a sunroof, colours etc). The NISMO kit wasn't, it had to be bought seperately.

little less lost now :D anyone got a pic of the NISMO kit on a coupe?

1999 white er34GTT lowerd, K&N pod filter,Greddy spark plugs, apexi power fc, blitz lm intercooler, apexi avcr, 3x BLM blitz guages where the orignal cluster were, 3" exhaust from turbo back, at the moment its gettin coilovers injectors pump and clutch, than it goes of to get a respray, plates say SLO*34

I suggest looking at the yahoo auctions for these parts and get slidewize imports to bring them in. Prices shouldn't be too bad if you're prepared to wait around 6-8 weeks for it and you have a higher chance of finding one in your factory colour to bolt straight on.

The front lip copies from car mate are selling for $280.00 excl. delivery (without paint or fitment). Even if delivery is another $30-$40 on top, I think that it will be cheaper than getting it from Japan.

Besides, it's a front lip... it is bound to sustain some damage and its just not worth spending so much money on ;) Sure I'd like to have a carbo fibre one too, but it just doesn't make sense to.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...