Jump to content
SAU Community

Recommended Posts

Hey,

I got a RB20DET in a silvia.

Just drove my car seems to be alot of steam or clear smoke not white coming from what seems to be around the rocker covers.....what could this be does not show on the temp dial thats its overheating.

But is has caused the car to stall twice so far and it wont kick over until you leave it for 5 mins.

I need any help i can get ASAP.

- Thanks Luke

Edited by RB20DET_Silvia
Link to comment
https://www.sau.com.au/forums/topic/92620-urgent-help-please/
Share on other sites

I'd stop turning the engine over incase you're doing any more damage.

Does it smell like oil?

Do you have oil in your radiator? Do you have a full radiator?

I'd be looking for oil or a exhaust leak - depending on what it smells like.

Head gasket let go perhaps? did it occur after spirited driving?

The temp guage will read normal if there is no water in the system....it needs water to function correctly.

If you drove it till it stalled and did that a couple of times you will have warped the head. If may drive ok once the leak is fixed but get a leak down test done and find out how bad it really is. Another problem is that the turbo would have overheated severely also so there is a good chance that once you fix the problem, be it water pipe, welsh plug or head gasket, the turbo may have damage to the bearing which can cause them to fail soon afterwards.

Another problem that you will have to check is piston shrinkage. If it turns out to be a head gasket blown and you drove it until it stalled there is a good chance your piston can shrink in size once cool again. Make sure you get this checked out by whoever does the head work - BTW it will cost at least $600 to repair the head if it is warped.

have you found the exact point the fluid is coming out?

i had some trouble with my r33 dropping coolant but only after giving it heaps, never lost any thru normal driving. it was dripping down off the bottom of the block. traced the leak back to a tiny pin sized hole in a coolant line close to the block, guess that the leak was forced due to higher temps/extra pressure in the lines.

have since covered and clamped the hole (no more leaks even after hard driving), and am replacing the lines this weekend.

not sure if this is relative, but may be worth checking.

maybe a cracked block?

Look, engines run on smoke.  Once all the smoke gets out they are dead.

aaaahhh, i see you are wise in da ways of da smoke. applies equally to electrical systems particualry those installed in pommy cars and affiliated with lucas aka the prince of darkness.

You will be looking at a minimum of around $1000 to do a head gasket on one of these if you go through a workshop.

$1600-$1800 if the head is bent (which it more than likely is)

$4000 if the pistons have shrunk.

Good luck, let me know if you have any issues. I have dealt with many of these.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...