Jump to content
SAU Community

Recommended Posts

hey how are u all goin?? my names kylie im 18 years of age.....and im a childcare worker!

5months ago i bought a R32 GTR 1989:) its all stock atm but when the money starts rolling in again it wil b getting work done to it! i would like to keep it as orginal as possible thought:P~

anyway im new to this site and thought i would say hello:)

hope to see u all around:):D

ill get a pic of my car up there very soon:)

Edited by ^MiSsY^
Link to comment
https://www.sau.com.au/forums/topic/92830-heyy/
Share on other sites

  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

dont think that was me......maybe it was! hahahaha oh well keep looking out for me hahahaha!

oh yeah i think i saw that one at one of the mc tuning days! i have a blue r32 gtst and got bogged on the circuit that day i think  :D

Link to comment
https://www.sau.com.au/forums/topic/92830-heyy/#findComment-1676178
Share on other sites

oh yeah i think i saw that one at one of the mc tuning days! i have a blue r32 gtst and got bogged on the circuit that day i think  :D

Was it the september tuning arvo? I have a dark blue R32 GTR and I was there....But I don't remember there being any 32 gts-t's :(

Yeah Missy I understand you're position, I have an office job and it's not easy owning a GTR on that kind of money!!! Then again I am a little bit older than you so the pay probably isn't quite so lousy (21) Takes forever to save up whenever I need money for the car though :)

Link to comment
https://www.sau.com.au/forums/topic/92830-heyy/#findComment-1676357
Share on other sites




  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...