Jump to content
SAU Community

Microtech Ecu In A R33

Tektrader69

By Tektrader69,
in Engines & Forced Induction

 Share

Recommended Posts

PHaT MR30 Grand Master

PHaT MR30

Posted
Posted

I have worked it out, but have not yet put it in practice... i dunno what you are using but in my case i am using an LT8.

Use the Aux Output through a relay and have it wired up so that the solinoid is on till the ECU reaches the Set RPM in the Aux Output menu (i think from memory it works best between 4500-4700rpm).

so basically what happening is the solinoid is switched on all the time, the ECU sends an output to the relay at set rpm to break the circuit and therefore turn the solinoid off...

i am fairly sure this is right, how ever i would need to check with sydneykid as to when the solinoid should be turned on and off...

got some diagrams of how to wire it up at home i can post up later.

Hope that makes sense

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      Mistakes were made, my R34 Story

      By MBS206 · Posted

      GTR front looks good. If you don't like it, I'll swap you a rolling shell R33 for it. Give you a fresh base to start with.
    • Kinkstaah
      Mistakes were made, my R34 Story

      By Kinkstaah · Posted

      soon I also prefer the old look. At least I have more clearance for wheels up front now.
    • MBS206
      SAU History 101

      By MBS206 · Posted

      @PranK I think a few links in the original post need fixing...
    • GTSBoy
      GTR R34 Limp Mode

      By GTSBoy · Posted

      Has equal chance of cleaning an AFM and f**king an AFM. I think you can work out what happened. When the Hitachi ECU sees the AFM die and goes into the associated limp mode, then it will start and run just fine, because it ignores the AFM and just runs on idle maps that will do what it needs to get it going. But there is no proper load signal, so that's about all it can do. My suggestion? If you don't want to go full aftermaket ECU, then get some R35 GTR AFM cards and some housings to put them in, in the stock location, and Nistune the ECU. Better to do a good upgrade than just replace shitty 40 year old tech with the same 40 year old tech.
    • steven7270
      GTR R34 Limp Mode

      By steven7270 · Posted

      So my car was recently having trouble starting on initial crank, I would need to feather the gas for it to start up but besides that it would start and run fine. So I clicked the idle air control valve (with throttle body cleaner) and cleaned the MAF sensors (with MAF cleaner). The start up issue was fixed and now the car turns over without the assist of the throttle, but the car is in limp mode and wont rev past 2.5k RPM. From what I understand the IACV would not put the car in limp mode, so I am to believe it is the MAF sensors, but it was running fine before and now I cant get it out of limp mode. I cleaned the MAF made sure the o rings were seated properly. Made sure the cables were plugged in properly, the cables also both read the same voltage. Does anybody know why this is or what could be causing this or how to get it out of limp mode?
×
×
  • Create New...