Jump to content
SAU Community

Recommended Posts

Hi the following R32 and R31 parts are in Canberra.

***********************************************************

RB20 DET Coil cover - Nissan badge removed in prep to vent it ....$25 ****

LH Headlight (GTS4/GTR/GTS/T), very good condition, no marks on glass $80.... SOLD

Front subframe - GTS4/GTR $120 ono. ****

Rear Subframe - GTS4/GTR $175 ono. bushes removed. ****

Front hubs (4wd) with wishbones, lower link and upper arms (pair) - No discs .................................$250 ono. *****

Front prop shaft $30 *****

Coil packs (6) - RB20/26 $150 - SOLD

RB20 Injectors (6) $100 - will separate for $20 each. *****

RB20 Silver top - Plenum/inlet manifold $80 - SOLD. Gone.

K&N panel filter - $50 ****

GTS4/T Steering wheel $50 ono. SOLD.

***************************************************

R31 PARTS

front suspension, monroe struts ..........................$100 pair ono. ***

NEW in packet front flexible brake hoses - Pair .....$70 ono ***

***************************************************

INTERESTED .......please PM me me or ph: 0433 297 644

Stephen

Edited by gts4diehard
Link to comment
https://www.sau.com.au/forums/topic/97957-r32-parts-gts4gtr/
Share on other sites

Jagule....Sorry No air con compressor.

Ryan R32

Yes I have the lower link, let me know if you are still after it. Let me know your email address by PM so I can send you a photo so that I can be sure we are talking about the same part.

Stephen

  • 2 weeks later...

Yes it will fit a GTR but I am not sure how good it is. I don't know if it squeaks or not. I would recommend getting a new one $180 from Nissan if you negotiate or replacing the bushes in your existing one - of course if you want this one so can get bushes pressed in and fit yourself it would be prefect for that.

$20 plus post.

Stephen

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...