Jump to content
SAU Community

Skyline Damaged In The Whole Cronulla Thing

SECURITY

By SECURITY,
in New South Wales

 Share

Recommended Posts

SECURITY Grand Master

SECURITY

Posted
Posted

i heard that there was a gold skyline with a black bonnet that got caught up in the whole cronulla thing today. apparently it got kicked and stomped on.

did anyone hear about this?

im not asking for opinions, i just want to know if it got out alright.

d00dz Grand Master

d00dz

Posted
Posted
people got bashed, stabbed and people arnt even safe in their own suburbs.

and your worried about 1 car?

yea whats the world comming to.

Heard there was a 1988 or 1989 skyline just off on bay street where the stabbing occured.... plates.. V.... somehting....

and some other cars....

SECURITY Grand Master

SECURITY

Posted
  • Author
Posted (edited)
people got bashed, stabbed and people arnt even safe in their own suburbs.

and your worried about 1 car?

no, me not asking wont change that fact though.

Edited by SECUR1TY
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Hendasto
      Lets play a game - What is causing my oil consumption?

      By Hendasto · Posted

      Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • Hendasto
      Are RBs worth building reliability wise

      By Hendasto · Posted

      At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • MBS206
      New kid on the block

      By MBS206 · Posted

      https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...