lunjiaow

I've replaced mine with an EL falcon heater hose, i think its EL.. but i know its one of the falcons. LOL!. Just went to autopro and they matched it up for me. Fits perfectly.

The dudes at the pits must have mistaken it for those tubed subwoofers LOL!..

Sounds great. Read up about 2rismo and his nos kit getting into the 12s easily. Well i need to upgrade my fuel system before i install the kit. Hopefully i can achieve a 12 second pass. Oh yeah so once you run out of gas, can we refill at BOC, or a performance store?

Anyone in perth have a nos system in their skylines, if so what kit are you running? I know it is illegal to have the whole system hooked up in WA. Other states can have it installed but disconnected at the bottle. This doesnt stop a few people from installing it though. Still deciding whether to put my one in or not.

You mean steering wheel puller? Can always get one from supercheapautos. i think they cost about $15 to $20.

Umm, i used 2mm washers, raised it roughly 10mm and bolt length, just get 10-15mm longer then stock.

Well i might buy one of those infrared thermometer, will eventually have to use one at work. So Chi, hows the temperatures in the engine bay?

LOL! you got it too. It must be like a 4 Door tradition.

Hmmm makes me want to try and RIP off that seal, but i dont have a proper gauge/tool to measure the engine bay temperature.

I dont think you have to rip off the seal. you can gentle take it off the clips, leaving them still on the plastic panel so in future you can put the seal back on.

You might as well get an aftermarket bonnet, if you want dramatic cooling.

Could try, bunnings, repco, autoone, supercheap (apparently having up to 60% off tomorrow), autopro. Hmm depends how high you want i guess.. well i raised mine and had troubles with the bonnet latch, so i had to put spacers (1cm nuts) behind the raidator support where those two 12mm bolts are.

Well i know that luxury cars that come out with HIDs from factory have those washers to clean the headlights, so probably is true. Why not just replace the stock ones back and go through pits, then install the HIDs again? I did that when i got yellowed.

Well took these pics just then. Probably used about 20 washers, 2 longer bolts for the rear with 2 washers so that the end of the bolt wont hit the bonnet denting it. I dont think this makes much of a difference in cooling down the engine bay. unsure if heat even escapes from there as there is a seal between bonnet and that plastic panel.

Dont raise it too high, or you wont be able to open the bonnet yourself again, making it a two person job.

PM Sent. Consider it sold!

So 8000k is illegal? Maybe i should take my ones out, just to stay legal.

Thats a bargain. Always wanted these, too bad your all the way in Brisbane. Well good luck with the sale.

ill take them for $500 if your willing to send to perth?

Nice! Im trying to get an M-Spec one too as the series 2 front bar is too hard to find at a low price. Would like to see what a four door looks like with m-spec bumper

hope that helps

Im not sure if there is a service schedule for the air/con system but all i did was put 00.400kg of R134a in it. seems to be working fine for now.

They are the same. The boot of the 4door is slightly longer, so pods and rear bars from the coupe wont fit at all.

Looks awesome with the intercooler showing now. I chopped up my bar somewhat similar to yours. You have three little fins hanging out from the top, you going to take them off? The bar is very flimsy isnt it? LOL!..

PM Sent