Willis

Cheers guys, i've got an ECU but the car still doesn't run! I'll let you know if I need another mike thanks.

I'll buy them off you. Seems like a good deal.

Alright so tonight I put in a 32 GTST ECU, fuel pump primes correctly. Unlike my old R32 ECU. Car won't start however. Cranks, a few cylinders fire. Then dies. AFM is unplugged. Swapped out the CAS. No change. I'm putting in fresh fuel tomorrow to eliminate that unlikely potential. I guess I'll track down a fresh fuel filter also. I've yet remove the CAS and spin and listen for injector tick etc.. guess that's tomorrow also.

At this stage I believe that the cause for issue is my ECU. I borrowed a mate's R33 ECU and the fuel pump prime's, appears to work correctly. Car cranks and starts but die's after a few seconds. Once I get a r32 replacement ECU I will continue to troubleshoot. Thanks for your input Willis

Bump for battery bracket to suit 32 GTST anyone? cmoney has the ECU & Throttle cable sorted!

Also the battery bracket if anyone has one!

Oh tops, that would be good. Yeah? Cool. I'm sure i'll remember when I see ya. I've bought alot of stuff haha. I'll swing by and grab it whenever you are free!

Hey mate, The sooner the better I guess? That'd be great if you could get the ECU back. Sydney West? Same here! PM sent.

Hi there, Chasing a ; WORKING ECU from a 32 GTST manual Throttle cable a 32 GTST manual. Local pickup is fine, i'm happy to pay postage for the above items also. Kindest Regards, Willis

Here is where i'm up to jiffo. Yes the thread has wandered, I guess I should have made a new one? Last night I bridged the fuel pump relay with a wire as suggested and the fuel pump worked. I do believe this means the issues is with the fuel relay control signal from the ECU?

Thank you for that, I will investigate this tomorrow. What should I expect on Pin #43 when the IGN key is turned to start? The engine cranks. It's possible for it to crank but not have the start signal?

Which ecu pin is the start signal? The one from the CAS?

Thanks for the suggestion Ben. Alright so I guess from here I will continuity check the earth line from the Fuel Pump Relay to ECU pin #18. If there is continuity, that means everything back from the ECU is fine. Does anyone know the criteria that the ECU requires to switch the fuel pump earth?

Done. Fuel pump works. Filled my 1.25L bottle attached to the lines in a hurry! I checked the relay again, it has power on one relay pin. No earth on the other side. The ECU switches the earth when certain criteria are met to power the fuel pump? For 5 seconds for prime, then upon a signal from the CAS?

Thanks for the reply; What is an Air Reg? What is it's function? MAP sensor / boost gauge. Is this required for the car to run? I must be missing the sensor. It bolts to the firewall? Near the brake master cylinder? The last one is factory shielded like that.. not sure where it goes? The Air Reg? The cold start thingo? Yeah that's in with the hoses hooked up to it. I think there's a plug on it also?

Alright I will give that a go.

I removed the relay's and tested them with power on the battery. It made an audible click as the relay engaged. How do I bridge it on the car?

Thank you for all the reply's btw! Still working on this car. It won't start, figured I would just add a post to this thread instead of starting a new. I've got a few plugs that I would like identified ^_^ Not starting symptoms; There is no fuel, i've pulled the lines off and cranked the car over. Nothing comes out. Initially replaced the fuel pump as I assumed it might have died. Still no fuel. Checked fuses, all good. Checked fuel pump relay in the boot, and the 2 x ign and acc relays in the passenger footwell. ECU displays a solid red light with accessories on. Goes out when cranking. Not sure if this is normal? Engine cranks, but doesn't fire. (no fuel obv) The following plugs are unplugged, as i can't find a home for them. This one, it's near the power steering fluid reseviour; And this one near the brake master cylinder; Also i'm not sure where this wire goes, is it an earth? Any idea's, or plug identification would be fantastic! I had hoped that the ECU had no power or something easy, but alas the light made me sad! Cheers!

I guess these would need a large 19" wheel at least? TE37 or the like? Cheers

I'm in love with your car. Stunning. Also love the wheels, but they are too wide for my little 32R!

Location?

As the title states; I'm after a standard r32 throttle cable to suit RB20DET. In good working condition please I'm located in Sydney but happy to have it posted. Wills

Also keen to know ^

Location and Price?

Thanks mate! Free Bumps!