Jump to content
SAU Community

Recommended Posts

the AC unit, was it the manual one or auto climate control?? im interested in upgrading to the auto one... do u have and how much??... (shipping would be needed as im in adelaide)

cheers,

prosman

the AC unit, was it the manual one or auto climate control?? im interested in upgrading to the auto one... do u have and how much??... (shipping would be needed as im in adelaide)

cheers,

prosman

It was the auto climate control, but it broke in the accident. Sorry mate.

Interested in front qaurter panel if you still have it. Can you send some pics of the panel + damaged bit to [email protected]

Regards

Laine

  • 2 weeks later...

Ok, the time for me to move is almost upon me.

I have to get rid of this stuff, so it's now all free, yes FREE.

Only catch is you have to come and pick it up I will NOT deliver any of this.

I have left:

Boot lid and spoiler

Whole rear half of shell (includes 2 rear side windows and rear windscreen)

Rear sub frame

Rear seats

Front lip spoiler

Passenger side quarter panel (slight damage but repairable)

whole roof trim

various bits of interior trim, mainly from the boot

Fuel tank

That's about it.

Please call me if you're interested in any of this. If no one takes it, it goes to the tip. I'd rather it go to someone who can put it to use than to the tip.

Ph number is 0418 233 525.

Located in Chatswood, Sydney.

i can come and grab:

front spoiler

boot

and possibly buy the shockies + springs if you have them.

happy to pick up this afternoon if convenient.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...