Jump to content
SAU Community

Recommended Posts

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

actually my 3" pipe is silent... i reckon it would scrape under the 90db mark it honestly isnt that lud at all.

as for stickers... the only stickers going on my car will be the SAU VIC stickers we end up making.

Link to comment
https://www.sau.com.au/forums/topic/10100-coppas-everywhere/#findComment-158057
Share on other sites

Hey Inark,

What 3" exhaust u got? I got Trust MX... I read the spec that the tip diameter is the same with Apexi N1, so was wondering if the N1 optional silencer will fit in nicely in the Trust MX? (Just need to drill a hole in the tip to hook up the silencer)

I actually don't think my exhaust too loud, but it should be able to make it quieter whenever you don't wanna attract too much attention.

Link to comment
https://www.sau.com.au/forums/topic/10100-coppas-everywhere/#findComment-160285
Share on other sites

Originally posted by pushead

i heard they superglue it onto the glass and you need some 'special chemicals' to get it off....

trust me i have done this before!

u just scrape it off then use sum bug and tar remover to clean the glue off! It can be taken off quite easily!

Link to comment
https://www.sau.com.au/forums/topic/10100-coppas-everywhere/#findComment-160372
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...