Jump to content
SAU Community

Recommended Posts

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

actually my 3" pipe is silent... i reckon it would scrape under the 90db mark it honestly isnt that lud at all.

as for stickers... the only stickers going on my car will be the SAU VIC stickers we end up making.

Link to comment
https://www.sau.com.au/forums/topic/10100-coppas-everywhere/#findComment-158057
Share on other sites

Hey Inark,

What 3" exhaust u got? I got Trust MX... I read the spec that the tip diameter is the same with Apexi N1, so was wondering if the N1 optional silencer will fit in nicely in the Trust MX? (Just need to drill a hole in the tip to hook up the silencer)

I actually don't think my exhaust too loud, but it should be able to make it quieter whenever you don't wanna attract too much attention.

Link to comment
https://www.sau.com.au/forums/topic/10100-coppas-everywhere/#findComment-160285
Share on other sites

Originally posted by pushead

i heard they superglue it onto the glass and you need some 'special chemicals' to get it off....

trust me i have done this before!

u just scrape it off then use sum bug and tar remover to clean the glue off! It can be taken off quite easily!

Link to comment
https://www.sau.com.au/forums/topic/10100-coppas-everywhere/#findComment-160372
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...