Jump to content
SAU Community

Recommended Posts

im looking at buying some 19s for my 32 gtr to have for everyday driving etc, im keeping my 17s for track etc.. looking at racing hart cxr in 19x10 or 10.5 if they fit.

can anyone confirm if the 10.5 rim fit. could i put 265/30/19s on the 10.5 rim??

please refrain from comments other than topic in question.

thanks, novak.

Link to comment
https://www.sau.com.au/forums/topic/101426-max-wheel-size-on-32-gtr/
Share on other sites

biggest you can go on a GTR imo is 20 x 8"

it all depends on the offset and how low you want to go

if you keep a decent ride height you can fit 10.5" wide 19s

but if you wanna drop it hard they will be too wide

well im buying 19s n wanted to really kno if i can fit 19x10 on without problems, my guards have been rolled, but no modifications... ill be stretching the tyres a little..

The answer is yes it will fit. Im using 19 x 10 on my r32 gtr with 265 30 19 yokohamas and they fit right to the gaurd. i tried using 275's but on a full car load they would hit the rear gaurds on bumps.

The bodyform r32 gtr uses 19 x 10.5 wheels with 275's stretched excepthe's pumped his rear gaurds by 15mm.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
×
×
  • Create New...