Jump to content
SAU Community

Recommended Posts

Hey all... has anyone got any comments?

600 x 300 x 80 Fmic

3 Inch exhaust dump back.. standard cat

Stainless exhaust manifold

Gt 30 with vg30 rear

Walbro pump

Sard fuel reg

Standard computer

Standard injectors

Iridium plugs

any thoughts?

post-24852-1137459394.jpg

Link to comment
https://www.sau.com.au/forums/topic/102129-r33-auto-gt30-dyno/
Share on other sites

they leave it in second cause it will go to redline without trying to change into third early.. but the gearing of second is prob only a little lower then a manual third

What gear is typically used for an auto on the dyno?

the lean spot at the top is the rev limiter..

Based on what I have seen, rev limiter = rich, not lean.

Regardles it can't be on the rev limiter from 90 kph to 110 kph.

My guess is the injectors are maxing out. Based on your PM, the fuel pressure at 50 psi plus boost is quite high, maybe the Walbro fuel pump can't handle the pressure and its flow is dropping off. That needs to be checked next time on the dyno.

:rofl: cheers :)

Edited by Sydneykid

I didnt get a print out from the dyno showing when the boost was coming on etc, but i know it was only running at 13 pound to make 228kw, and from driving it i would say just over 4

The dyno graph looks like a fairly straight line so it obviously isnt surging or laging to badly.. i think 40kph on the graph is around the 3000 rpm mark.. i dont know if that helps... i could prob go back to the dyno and get the other print out if it will help..

can you tell me what the lag is like? I have a GT30 with a VG30 rear too..

Full boost in second at 4900rpm..........

GT30 with VG30 housing (700177-5011) TO4S 7 blade wheel

Nismo 550cc Injectors

Walbro 220lph Fuel Pump

FMIC (600x300x75)

Full 4 inch intake

powerfc and Datalogit

Q45 afm (90mm)

Full exhaust thats huge, hi flow cat

95ron fuel

220rwkw, and 470nm of torque at 15psi

Full boost in second about 4800 - 5000

Full boost in third about 4500

Full Boost in 4th is about 4200

Fitting a RB25 Standard exhaust housing to it on the weekend. I think the VG30 may have been ground out too much.

Edited by The Mafia
it can't be,  the lean spot is the tuner backing off the throttle, hence going to a lighter load point, also why the power drops off..

It's lean before it gets to that point.

I had the Walbro. Doesn't seem to flow very well up high. Ditched it.

Same problem i had with my walbro :w00t:

he why its being used as a lifter pump rather than a main pump.

Very crappy things the walbro's.

I was from 12afr's into the 10's with just a fuel pump change and nothing else.

so what are you running now?

and if its a external pump where did you mount it.. cheers

Same problem i had with my walbro  :)

he why its being used as a lifter pump rather than a main pump.

Very crappy things the walbro's.

I was from 12afr's into the 10's with just a fuel pump change and nothing else.

i just went and picked up my other dyno sheet showing the boost...

Damm gizzmo ebc... cheap and nasty... set on 13psi

but it dosent hit 13pound till 6000rpm then dies again.. grrrr...

anyone have any suggestions on smothing out the boost line?

makes good power at 7000rpm at only 12 pound.. hmmm B)

post-24852-1137566532.jpg

they do it in the gear which is closest to a 1:1 ratio. so im told.

they did mine in 3rd(left Overdrive off)

IMO that PSI reading is weird

mine goes straight up to what its set using a $22 controller.

doesnt fade off untill 5,500-6000rpms

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
×
×
  • Create New...