Jump to content
SAU Community

Recommended Posts

  • Replies 48
  • Created
  • Last Reply

Top Posters In This Topic

Well the good news is i've fixed my gearstick issue (genuine toyota parts :P) it prob needs a 500-1000km run to bed in properly but meh a nite at the drags should be just as good.

The bad news is.... i'm all out of excuses.... it's just me and machine now! So providing my visa card decides to start working again i'll be there just after 5pm

;)

Seems I don't even need to post my times :P

Did a 13.0 @ 112.9mph (1.79sec) still with gear problems. The clutch appears to be engaging even with my pedal on the floor (car is creeping forward at the lights, had to use my handbrake to try and hold it back). I'll try and get that looked at b4 next wed and head back out there again.

Still though, I did a new pb for 60ft, ET, TS so i'll be back again shortly :D

Hey Ben i was there watching you, i was with some people in the stand taking a break when you started and they were like hehehe he's missed a gear! but silently i knew you had troubles.

I was happy with my outing though, a 14.1 at 97mph stock except exhaust!

ben, it sounds like you have a hydraulic problem (possibly slave cylinder). I had a smiliar thing on the GTR. just enough of a slight leak so that it wouldn't push the fork far enough to completely disengage the clutch, which meant creeping, and difficult gear slection. a new slave is only about $70 from nissan and you can change it youself in about 10 mins. if you are skinny you can probably even do it without jacking up the car (needless to say, i had to jack it up!).

Yes it certainly has an issue, hydraulic or whatever i'm not sure but i'll be getting it looked at sometime hopefully before next wednesday so I can get back out there again.

I'm not resting until I see 11's :P




  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...