Jump to content
SAU Community

Recommended Posts

  • Replies 48
  • Created
  • Last Reply

Top Posters In This Topic

Well the good news is i've fixed my gearstick issue (genuine toyota parts :P) it prob needs a 500-1000km run to bed in properly but meh a nite at the drags should be just as good.

The bad news is.... i'm all out of excuses.... it's just me and machine now! So providing my visa card decides to start working again i'll be there just after 5pm

;)

Seems I don't even need to post my times :P

Did a 13.0 @ 112.9mph (1.79sec) still with gear problems. The clutch appears to be engaging even with my pedal on the floor (car is creeping forward at the lights, had to use my handbrake to try and hold it back). I'll try and get that looked at b4 next wed and head back out there again.

Still though, I did a new pb for 60ft, ET, TS so i'll be back again shortly :D

Hey Ben i was there watching you, i was with some people in the stand taking a break when you started and they were like hehehe he's missed a gear! but silently i knew you had troubles.

I was happy with my outing though, a 14.1 at 97mph stock except exhaust!

ben, it sounds like you have a hydraulic problem (possibly slave cylinder). I had a smiliar thing on the GTR. just enough of a slight leak so that it wouldn't push the fork far enough to completely disengage the clutch, which meant creeping, and difficult gear slection. a new slave is only about $70 from nissan and you can change it youself in about 10 mins. if you are skinny you can probably even do it without jacking up the car (needless to say, i had to jack it up!).

Yes it certainly has an issue, hydraulic or whatever i'm not sure but i'll be getting it looked at sometime hopefully before next wednesday so I can get back out there again.

I'm not resting until I see 11's :P




  • Similar Content

  • Latest Posts

    • Get something that can spray a bit, something like I'd use is a pressure pack for weed sprayer. I use one with degreaser. Spray it on (make sure you're fully covered up, you don't want that shit on you, especially face/eyes). Alternatively, a paint brush will help here as you can brush and work at the stuff quite aggressively.   Be aware, citric acid can eat metal away and will cause it to rust more later. So make sure you neutralise it when done, and give the fresh metal some protection. That hanger, I'd honestly bin and get something like the Frenchy's drop in replacement. The tank, again, I'd look for something else to replace it with. Remember, as metal turns to rust, it means there's less metal there now. So some patches of your fuel tank are likely to be quite thin.   Personally, Id focus on the front end of things, IE, how did the injectors get clogged if they're meant to be after a fuel filter. Then, once the front is sorted, I'd rig something up, even like a small surge tank, and make sure the engine is now running and all behaving. Then I'd replace the fuel tank and fuel hanger and pump. Also, I'd already be preparing to ditch your fuel filter...  
    • That's looking great! Are you planning to do things like all hidden wiring with it, or you're planning to have it look more like we'd expect an RB in an engine bay to look like?
    • Haha thanks everyone, I'll take everyone's suggestions into consideration. If I do eventually choose a car ill post it here update on the mods I do.
    • I found the ingredients at larger amounts from a Coffee Shop. 1kg Citric Acid for €8.50 500g Baking Soda for €2.50 I tried it out tonight distilled water (I got from my ACs) and dish soap. It does get bubbly with dish soap. In just two hours the hanger has improved significantly and rubbing against any remaining rust seems to flake it off. I'm going to leave it a little bit longer and see how it goes. I have read that someone even used this solution in an ultrasonic cleaner to clean a seized water pump which brought it back to life.
    • If you like more modern stuff than the R series, you should check out a V37 400R, they are pretty mod friendly
×
×
  • Create New...