Jump to content
SAU Community

Recommended Posts

Hi,

Im looking at getting a daily driver, with the option to turn it into a track-car later on (2years+)

I am looking at getting a Dr30 or AE86 (jdm not aus spec).

Basicly im looking at the cost to run both cars and how hard it is to find parts for them? I know with the 86 you can go to your toyota dealer and get parts from them and find parts here very easy but im not sure about the dr30.

any input would be nice

ohh what what type of fuel would i need to run in the fj20? bp98?

thanks michael :)

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/
Share on other sites

heaps of parts for either, just depends on if you want a bigger car or smaller car. DR30 would be the faster car for track work. IMO if you really want a sweet track car(grip race) get a old scool Rotor RX3, RX2 RX7 even! With the right setup they go hard, just look at the field in Improved Production! But definatly the DR as a street car!

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2052116
Share on other sites

Parts for a DR30 aren't very expensive (except oil pumps) and my DR30 was far nicer than friends AE86's. Definitely go the DR30, indestructible engine as long as you keep the sump off the oil pickup, tough rear end and it doesnt have a trailer axle in the back

hey adam, where do you get most of your parts from? do you have to soruce them from japan or can u get them from nissan? (im not general parts which wear over time)

and thankyou everyone else for the reply :happy:

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2052356
Share on other sites

ae86's are rust heaps, i own one (oz spec upgraded to japanese rear and silvia front). I also work for an importer and only 1 out of 10 ae86's we inspect that are cheap have acceptable amounts of rust. Usually their owned by budding amatures with small budgets in japan, so maintenance is not a priority. The ones that are well looked after and clean are owned by proper enthusiasts and a good clean runner will cost you at least 12k to anywhere up to 23k for fully restored ones. For that sorta money you can easily land an R33 GTSt that's 10 years newer.

In comparison most DR30's we look at have easy lives and aren't as neglected.

Purely from a value for money perspective, I'd say go with the DR30... you just don't get as good a car if you bought an AE86 for the same amount.

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2052516
Share on other sites

ae86's are rust heaps, i own one (oz spec upgraded to japanese rear and silvia front). I also work for an importer and only 1 out of 10 ae86's we inspect that are cheap have acceptable amounts of rust. Usually their owned by budding amatures with small budgets in japan, so maintenance is not a priority. The ones that are well looked after and clean are owned by proper enthusiasts and a good clean runner will cost you at least 12k to anywhere up to 23k for fully restored ones. For that sorta money you can easily land an R33 GTSt that's 10 years newer.

In comparison most DR30's we look at have easy lives and aren't as neglected.

Purely from a value for money perspective, I'd say go with the DR30... you just don't get as good a car if you bought an AE86 for the same amount.

thanks for that funky :D

i've been checking out some of the auction in the area which the person i am importing through uses, and their are alot of ae86 but as you said the auction sheet always mention rust...

only problem i have seen is that there arnt many dr30 for sale

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2052547
Share on other sites

Go the older model DR30 sedan.. As far as I'm aware body panels should be interchangable with Aus spec MR30's.. FJ and GZE are both awesome engines... Steering feel will be slightly better in the 86 due to R30's running steering box. Then there's the DR's indipendant rear wich seems to work well even though its a trailing arm set up. My mate uses premium with no hassels

DR30 as a daily for the win.... nothing like the oldschool grunt of the FJ when you knock it back a gear :D Bang for buck u cant loose

What sort of figures are you looking at for a clean DR30 landed if you don't mind me asking?

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2052601
Share on other sites

Engine parts are easy through Stewart Wilkins in Sydney

Other various bits I've gotten through Jaustech for DR30 specific items, and general Nissan wreckers for common R30 parts

And I had most work done by my Triumph mechanics, so they can't be too hard to work on, they'd never seen one before

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2055818
Share on other sites

Mikey, I've seen DR30's with immaculate paint (still stock colour) for around 5k. Sure, it could have a few problems but if the original paint is that good, it goes to show the quality of a car.

FJ20 is the founder of nissan 2ltr turbos really.. And it's a bulletproof beast to boot.

DR30 FTW!

Link to comment
https://www.sau.com.au/forums/topic/111290-dr30-or-ae86/#findComment-2062226
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Actually everyone on the roads was really well behaved. The only person that did any minor tailgating was a local hoon in a Turbo Focus. Unfortunately we weren't going the same way so there was no grand initial D touge battle. Lots of people pulled over and let me through. The amount of "Hey man nice car, omg skyline, nice 34 man woo" was suprising. Like really suprising. Like almost annoying. My partner was obviously surprised, she'd never seen anyone in the real world point out the car/like the car/want to chat about the car before, so to have like 3 people per day mention it was notable, I could finally say SEE? SOMEONE THINKS THEY'RE COOL. Everyone was also pretty suprised about the weather. Every day was dry and about ~13-14C. Mount Wellington had a sign that said they close the gates at 9pm and I was heading up there at about ~7:30. It was VERY apparent that conditions were getting significantly worse by the minute on the way up and down. The road on the mountain was terrible though, it's no driving road. I have various suspension related questions now. Luckily it was only about 20 minutes from where we were staying to the top of the mountain as said Google maps. We only had the 2 nights in Hobart. We went to the Farm Gate Market though which was really good - And went down to the Hastings Thermal springs/caves down there during the day. I'd definitely be up for going back again, so luckily there's a few more sights yet to see. Didn't get to do the west coast/queenstown/cradle mountain so this was supposed to be a 'scouting' trip anyway of sorts if I were to one day do/take part in/organize a more car-focused trip. As for the boat, it wasn't bad. Well it was bad, but not in the way you're thinking. We did the night trip which leaves at 6:45 (though you have to be there ~2 hours earlier) and arrives the next morning at about 6am. There is nothing to do on the ship. If you plan accordingly and bring a book/tablet/show to watch/charger you can just chill out, take some Travacalm and just sleep through it. The food there is an extremely basic buffet that costs $32 a plate, or $14 for a $3 pizza. The way back we had a travel kettle and a few different types of cup noodles and made our own tea/coffee in the room. This was a far superior way to do it. At the very least book one of the rooms with beds. I guess as we were in the off season we didn't have room mates. You get an option for rooms with 4 beds (2x bunks) or a room with just the two bottom beds. There's also some option for a deluxe queen bed but it's much pricer. We've been on sleeper trains in Asia before so we figured this is similar (and it was)
    • You just gotta be really, really, really clear and decisive with what you want your end product to be. 99% of people who want this conversion aren't "I want to run a 295 front tyre!" so they don't really need the widebody. They just want the OEM body to look a little less dumpy, so bonnet, bar, skirts job done with some camber, stretch, slam. It's when you want that, but then decide to pivot later you get big problems. See also if you're willing to get an all in one fibreglass bar, and you're willing to accept fibreglass problems like cracking the entire item on a driveway, instead of just a piece attached to the bottom, etc etc etc. Decide this all before buyin'.
    • After @Kinkstaah debacle, I'd never want to try and get it right 😛
    • The hood lines up with the fenders. The front bar doesn't perfectly line up with the fenders where the wheel arch is. You have to 'squeeze' the front bar 'in' as it wants to naturally flare out and be longer on the sides. There's a few threads where people notice this when they only swap a GTR style bumper and front bar. Unless you have genuine OEM items - you may be better served getting conversion kits. There are GTT bumpers to fit GTR hoods. There are GTR hoods (non genuine) to fit the GTT bracketry. MAY  
×
×
  • Create New...