Jump to content
SAU Community

Recommended Posts

It has come time to sell the R33 which I bought 5 years ago from a local importer as I am building a new house and need $$ for it and have no room to store 3 cars at the new place. Bodykit came with the car and it was mechanically stock when purchased.

The car has spent the last few months sitting in the garage as I have another car as a daily driver.

General

1996 Series 2 M-Spec

White

90,000 KM On Clock

Twin Air Bags

Climate Control

Full electrics

2 Way Electric Sunroof

Prestige Alarm System

Engine / Performance Parts

Garrett GT30 Ball Bearing Turbo

(0.70 A/R Polished Compressor Housing, 0.82 A/R Exhaust Housing)

Braided Oil / Water Lines To / From Turbo

XTR Exhaust Housing Blanket

45mm Turbosmart External Wastegate With 1 Bar Spring

Custom Made Steam Pipe High Mount Turbo Manifold

K/N Pod Filter With 3-Inch Polished 304 S/S Intake Pipe

R33 GTR Stealth Bov’s

6 x Sard 550cc Side Feed Injectors

Bosch 044 600HP Intank Fuel Pump

Z32 80mm Air Flow Meter

9 Puck Single Plate Cushioned Ceramic Xtreme Clutch With 1800lbs Pressure Plate

4.8 kg Chrome Molly Super Light Weight Flywheel

HKS Adjustable Exhaust Cam Gear

HKS 600x300x76 Tube And Fine Intercooler

Custom Made 304 S/S 2.5 Inch Mandrel Bent Intercooler Piping

Cusco Oil / Air Separator

Custom Made 3 Inch Heat Insulated Mandrel Bent Dump Pipe And External Wastegate Adapter

Custom Made 3 Inch Mandrel Bent Exhaust From Dump Pipe Back

Highflow 3 Inch Cat and Polished 3 inch Rear Magnaflow Muffler With 4inch Tip

HKS Ionized Oil Cap

C’s Quick Shifter

Meridian Motorsport Oil Cooler

Suspension/Brakes

Blistein Shocks

Custom made king springs front and back (300lbs front, 250lbs rear)

Front strut bar

Rear Stabilizer Bar

Whiteline front/rear adjustable swaybars

Subframe alignment bushes

Whiteline castor/camber kits

Hicas Locking Bar

Wheel alignment to track specifications

DBA GTR 324mm slotted front rotors

Ferado DS2500 Pads front Comp 2 rear

Mechanical LSD Diff

Electronics

HKS EVC 3 Electronic Boost Controller

Apexi Power FC Programmable ECU

Apexi Power FC Hand Controller

Pivot Adjustable Shift Light

Blitz Turbo Timer

Apexi 60mm EL 2 Electric Boost Gauge

Apexi 60mm EL 2 Electric Oil Temp Gauge

Apexi EL 2 Gauge Controller

Trust Dual A Pillar Gauge Holder

Interior

Custom Painted Electric Blue Interior Highlights

Jetspeed EL White Faced Display Dash Kit

Trust Chrome Gear Knob

Alpine 3 Disk In Dash CD Player

Kenwood Front Splits

NISMO car mats

Custom Made Leather Electric Blue Handbrake & Gear Boots

Blue Recaro SR3 Front Seats

ERG 5-point harness

Exterior

Nismo 400R Front Bar With Grill Insert

Nismo 400R Side Skirts

Nismo 400R Read Bar

Stealth Rear Boot Lip

18-Inch White With Polished Lip Starcorp Racing Rims, 8.5 Inch Front, 9.5 Inch Back

235 x 40 Front, 265 x 35 Back Hankook K104 Tyres (80% Thread Left)

Clear Side Indicators

Tinted 30% Front And Sides, 20% Back Window

NISMO Carbon Fiber Pillar Garnish

Performance

1 Bar Boost – 260kw@wheels (Racepace Dyno)

1.4 Bar Boost – 312kw@wheels (04’ Autosalon Dyno Comp)

Car serviced every 5000km with full synthetic oil.

All Mechanical / Electrical work carried out by Ice Performance

Have receipts for most parts purchased for the car.

Car is setup for the track, throw some semi comps tyres on there and you will do some good times.

In Melbourne

Price - Looking for $31,500 ONO but open to resonable offers

Other pics can be emailed on request.

post-11694-1143452690.jpg

post-11694-1143452723.jpg

post-11694-1143452750.jpg

post-11694-1143452784.jpg

post-11694-1143452824.jpg

post-11694-1143453244.jpg

Link to comment
https://www.sau.com.au/forums/topic/111294-my-300rwkw-96-gtst/
Share on other sites

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

  • 2 weeks later...
if u drop to 20 i will buy ...coz its only a r33 gtst ! and a 1996 model ......!

even if u put over 10g under the bonnet u wont get a higher prices then 24g

Theres more than 20G I have spent on engine, suspension, interior, brakes etc etc.

Once you start modifying these things you will realise the cost, time, effort and headaches they can bring you.

When I get my next track car I will be looking forone that has already had alot of time and $$ spent on it coz I now realise what an effort is required.

  • 1 month later...
  • 1 month later...
  • 4 weeks later...

That's the best Series2 I've seen! Looks very professional too..not dodgy mods like some I've come across. I'm after a zed :) but I'd definately consider this if I had another few grand. Best of luck.

  • 4 weeks later...
  • 2 weeks later...

If this car was registered in Adelaide it would be asleep in my garage at the moment!

I just don't think I would have a hope in hell of getting changeover of rego :(

That is a fark load of car for $23,500

Why would people not want to buy this if they where in the market for an R33?????? Maybe they're worried about getting defected?

Anyway, best of luck with the sale INASNT it seems like a very clean, well set up car :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...