Jump to content
SAU Community

Recommended Posts

Hey guys,

Been reading on this forum for quite some time now and now finally deciding do to some purchasing of an r33.

what i was wondering is what peoples opinions are of an r33 gtst coupe(most likely series 2) being used as a daily driver. I have wanted one for quite some time now but because of age and insurance always decided against it. I am planning on using my line to take me to work and back everyday, which is a 40km drive(usually 1 hr), so 80km a day on weekdays.

What I am basically asking -is this a bad idea in your opinion? ;) What would be the pros and cons of this?

Cheers guys. :D

Link to comment
https://www.sau.com.au/forums/topic/116231-little-adviceopinions/
Share on other sites

Umm I wouldn't see a problem in using it as a daily driver... Just about everyone on here does.

Pros on it would be you get to cruise for along time everyday in a Skyline :D

I guess ull be clocking up some k's on it quick.. but hey cars are ment to be driven!

With the fuel prices its gonna cost abit each week.

At 80K's a day you'll go through a full tank of premium per week so its up to you if you could afford it, assuming you get around 430K's out of a tank - ~$70 nowadays

For me, the highlight of the day is the drive to and from work so its worth it hehe

Good points guys.

Petrol will be no problem, plus I have plans to get my hands on a power fc and some kind of ebc.

Should have mentioned that one of the things that has me worried is reliability. At the moment I am driving a 92 Ford Falcon which is a work horse but a real bore to drive.

Mods will be kept fairly simple as I'm not searching any numbers(will c if I can keep this mindset once i've purchased the car :) ). plans are power fc, ebc, fmic, tbe, air filter and other suspension and brake mods.

I dont plan on keeping the ford. So am I gonna be spending most of time in hire cars while my car is in the workshop? :rofl: or can someone here speak on experience and say I should be ok?

Maybe a gtr would be a different story?? :ermm:

Depends if you buy a lemon - get a prospective buy checked out thoroughly (compression test!).

The RB25DET is a very reliable engine and can handle mods. Just don't expect 2JZ internals when you strap on a turbo and run hi boost.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...