Jump to content
SAU Community

Recommended Posts

Hey i just bought some new tyres and damn are they noisy. with my old ones which were wasted you did hear alittle bit of that ticking sound now its louder with these tyres. any maintenance tips to help the noise decrease or go away?? Correct me if im wrong but seems to be abit better when the tyres are warmed up abit.

Link to comment
https://www.sau.com.au/forums/topic/116583-noisy-tyres-hate-em/
Share on other sites

Hey i just bought some new tyres and damn are they noisy. with my old ones which were wasted you did hear alittle bit of that ticking sound now its louder with these tyres. any maintenance tips to help the noise decrease or go away?? Correct me if im wrong but seems to be abit better when the tyres are warmed up abit.

new tyres should be quiet, generally as tyres get older they will be noisier (wear, tread goes hard etc)

what tyres are they? did u get them brand new or second hand?

were they balanced when u put them on? i have found that i had a bit of noise at freeway speeds with my old tyres and so i got them rebalanced and it went away.

i just got new tyres today and my car feels like a limo compared to before :ban::D:P

What a load of horse @$#@! Why post if you have no idea what you're spouting! :blink:

The only time you should ever run less presure in the rear than the front is in a drag situation with the right tyres and suspension set up to handle it.

For tyres of that staggered size front to rear on the street, I'd recommend 36psi in the front and 38psi in the rears for even tyre wear, best handling and best fuel economy. 40 and above is too much and too rougher ride for the street plus at those pressures and your width of tyre it's highly likely that you'll get over inflation wear.

On to you problem at present. Your tyres, although being of the cheaper (nastier) variety, they should be quiet when new especially being new, balanced and wheel aligned! So i'd be heavily leaning towards rear wheel bearings!

With new tyres eliminating the old tyre growl you can now hear the wheel bearings. You typically hear them at highway speed as they're spinning at high speed making them more audible.

I'd jack the rear of your car up so your rear wheels are off the ground, sit the rear on jack stands and chock your front wheels and spin the rear wheels up to 100km/h and I'll bet you hear the growl still

Hope that helps :(

Edited by ellie

hahah nah I take too much care of my car to do stupid stuff in gravel carparks. i'll check rocks and stuff. after some further research they said these tyres are known to be loud so yeh great. As soon as they go bald im going for some toyo's :cheers:

hahah nah I take too much care of my car to do stupid stuff in gravel carparks. i'll check rocks and stuff. after some further research they said these tyres are known to be loud so yeh great. As soon as they go bald im going for some toyo's :D

I wonder how they'll go bald??? ;)

lots of sensible driving. Yeh the noise of the tyre is annoying. Im thinking of just changing them. Just a warning to you guys dont buy these brand tyres noisy az. I wonder why tyres do make the ticking sound its just crap hehe.

you can also hear it when like doin 60km/h also but once you drive for a while the tickin sound seems to go cause the tyres warm up. But for the time they are ticking embarrassing cause its like people think something wrong with ur car. should of stuck with the pirellis or did some research as people say they are loud as tyres. didnt think new tyres could be loud i guess its the compound or whatever.

I have never heard any tyre noises in my life..

Even on the shitty camry with new tyres and even old tyres which are bald ass..

I got pirellies (whateva spelling) on the camry and no noise!!

hmm as for pressure, always best of a 30-32 combo..

^^^^ Just about all tyres are noisy buggers. When you are fairly close to a major road, the first thing you notice is the tyre noise. After a few hundred metres you tend not to notice the engine / exhaust noise, but the tyre noise always carries a long distance.

As for ticking, I would be inclinded to think that there was a nail or screw in the tyre. Sometimes they are hard to see too, and you sometimes need to take the wheel off the car to easily tell where the nail / screw is.

Ticking might also be from brake pad wear indicators (strange but it could be). Dude tyre noise is NOT a ticking noise. Its quite posible these tryes are actually quieter, and you are now hearing another noise that was previously masked.

BTW, I run 38psi front, 36psi rear and have PERFECT tyre wear, took me 6months to work it out tho. I think it depends on the car and your driving style.

heheh also the pressure depends on the tyres you have!!

I had some shitty 205s on my car ages ago.. Anyways even with 30psi, i was spinnin in 1st,2nd and 3rd.. with a stock car!!

even set at 25psi, it was shit.. just kicked out easily..

Anyways back on topic.. next time i drive im gonna try n hear my tyres lol..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...